MAGGIANO'S

Proper cooling methods used: adequate equipment for temperature control — Inspector Note: Observed multiple TCS food items tightly wrapped while cooling in the walk-in cooler. CA: 1. Cooling shall be accomplished in accordance with the time and temperature criteria specified under DPH Rule 511-6-1-.04(6)(d) by using one or more of the following methods depending on the type of food being cooled: (i) Placing the food in shallow pans; Pf (ii) Separating the food into smaller or thinner portions; Pf (iii) Using rapid cooling equipment; Pf (iv) Stirring the food in a container placed in an ice water bath; Pf (v) Using containers that facilitate heat transfer; Pf (vi) Adding ice as an ingredient; Pf or (vii) Other effective methods. Pf 2. When placed in cooling or cold holding equipment, food containers in which food is being cooled shall be: (i) Arranged in the equipment to provide maximum heat transfer through the container walls; and (ii) Loosely covered, or uncovered if protected from overhead contamination during the cooling period to facilitate heat transfer from the surface of the food. COS: The TCS food items were uncovered or loosely covered during the inspection to allow proper cooling.

Insects, rodents, and animals not present — Inspector Note: Observed multiple drain flies/gnats near the handwashing sink in the back kitchen during the inspection. CA: (k) Controlling Pests. The presence of insects, rodents, and other pests shall be controlled to minimize their presence on the premises by: 1. Routinely inspecting incoming shipments of food and supplies; 2. Routinely inspecting the premises for evidence of pests; 3. Using methods, if pests are found, such as trapping devices or other means of pest control as specified under subsections (6)(e), (6)(m), and (6)(n) of this Rule; Pf and 4. Eliminating harborage conditions. Advised the person in charge to clean and sanitize the area, eliminate standing water and food debris, and contact pest control as needed.

Adequate handwashing facilities supplied & accessible — Inspector Note: Observed the handwashing sink at the bar blocked and containing pasta and vegetable pieces. Coffee grounds were also observed in the handwashing sink in the main kitchen. CA: (o) Using a Handwashing Sink. 1. A handwashing sink shall be maintained so that it is accessible at all times for employee use. Pf 2. A handwashing facility may not be used for purposes other than handwashing. Pf 3. An automatic handwashing facility shall be used in accordance with manufacturer’s instructions. Pf Advised PIC that handwashing sinks must remain accessible and be used only for handwashing.

Contamination prevented during food preparation, storage, display — Inspector Note: Observed dirty pots and pans stored on the floor during the inspection. CA:(q) Food Storage. 1. Except as specified in paragraphs 2 and 3 of this subsection, food shall be protected from contamination by storing the food: (i) In a clean, dry location; (ii) Where it is not exposed to splash, dust, or other contamination; and (iii) At least 6 inches (15 cm) above the floor. 2. Food in packages and working containers may be stored less than 6 inches (15 cm) above the floor on case lot handling equipment if the equipment can be moved by hand or by conveniently available apparatuses such as hand trucks and forklifts. 3. Pressurized beverage containers, cased food in waterproof containers such as bottles or cans, and milk containers in plastic crates may be stored on a floor that is clean and not exposed to floor moisture. COS: PIC instructed employee to remove items from the floor and store them at least 6 inches off the ground.