Sarku Japan

Proper cooling methods used: adequate equipment for temperature control — Inspector Note: Observed just prepped sushi cooling with lids on. CA: (e) Cooling Methods. 1. Cooling shall be accomplished in accordance with the time and temperature criteria specified under DPH Rule 511-6-1-.04(6)(d) by using one or more of the following methods depending on the type of food being cooled: (i) Placing the food in shallow pans; Pf (ii) Separating the food into smaller or thinner portions; Pf (iii) Using rapid cooling equipment; Pf (iv) Stirring the food in a container placed in an ice water bath; Pf (v) Using containers that facilitate heat transfer; Pf (vi) Adding ice as an ingredient; Pf or (vii) Other effective methods. Pf 2. When placed in cooling or cold holding equipment, food containers in which food is being cooled shall be: (i) Arranged in the equipment to provide maximum heat transfer through the container walls; and (ii) Loosely covered, or uncovered if protected from overhead contamination during the cooling period to facilitate heat transfer from the surface of the food. COS: PIC loosely covered sushi to allow it too properly cool.

Physical facilities installed, maintained, and clean — Inspector Note: Observed a buildup of grease in the corner of the prep grill by front food service station unclean to sight and touch during time of inspection. CA: (2) Design, Construction, and Installation. (a) Floors, Walls, and Ceilings, Cleanability. Except as specified under subsection (2)(d) of this Rule and except for antislip floor coverings or applications that may be used for safety reasons, floors, floor coverings, walls, wall coverings, and ceilings shall be designed, constructed, and installed so they are smooth and easily cleanable. Advised PIC to deep clean front food service area.

Food-contact surfaces: cleaned & sanitized — Inspector Note: Observed All sanitizer buckets below 200 ppm quat during time of inspection CA: n) Manual and Mechanical Warewashing Equipment, Chemical Sanitization - Temperature, pH, Concentration, and Hardness. A chemical sanitizer used in a sanitizing solution for a manual or mechanical operation at contact times specified under subsection (8)(b)3 of this Rule shall meet the requirements specified in DPH Rule 511-6-1-.07(6)(g), shall be used in accordance with the Environmental Protection Agency (EPA)-registered label use instructions P, and shall be used as follows: 1. A chlorine solution shall have a minimum temperature based on the concentration and pH of the solution as listed in the following chart; P Concentration Range Minimum Temperature MG/L PH 10 or less oF (oC) PH 8 or less oF (oC) 25-49 120 (49) 120 (49) 50-99 100 (38) 75 (24) 100 55 (13) 55 (13) 2. An iodine solution shall have a minimum temperature of 68°F (20°C)P minimum concentration between 12.5 ppm and 25 ppm, P and pH of 5.0 or less or a pH no higher than the level for which the manufacturer specifies for the solution to be effective; P 3. A quaternary ammonium compound solution shall have a minimum temperature of 75ºF (24ºC), P have a concentration as specified in DPH Rule 511-6-1-.07(6)(g) and as indicated by the manufacturer’s use directions included in the labeling, P and be used only in water with 500 ppm hardness or less or in water having a hardness no greater than specified by the EPA-registered label use instructions; P 4. If another solution of a chemical specified under paragraphs 1 through 3 of this subsection is used, the permit holder shall demonstrate to the Health Authority that the solution achieves sanitization and the use of the solution shall be approved; P 5. If a chemical sanitizer other than chlorine, iodine, or a quaternary ammonium compound is used, it shall be applied in accordance with the EPA-registered label use instructions ;P and 6. If a chemical sanitizer is generated by a device located on-site at the food service establishment, it shall be used as specified in 1-5 of this subsection and shall be produced by a device that: (i) complies with law as specified in sections 2(q)(1) and 12 of the Federal Insecticide, Fungicide, and Rodenticide Act (FIFRA), P (ii) complies with 40 CFR 152.500 Requirement for Devices and 40 CFR 156.10 Labeling Requirements, P (iii) displays the EPA device manufacturing facility registration number on the device, Pf and (iv) is operated and maintained in accordance with manufacturer’s instructions. Pf. 7. On-site chemical sanitizer generating equipment with active ingredients, such as copper, must be registered as pesticides. The active ingredient may be part of the equipment or separately added. COS: PIC replaced sanitizer buckets to the correct conetration of 200 ppm quat

Food-contact surfaces: cleaned & sanitized — Inspector Note: Observed interior roof of ice machine built-up with black organic growth during time of inspection. CA: (7) Cleaning of Equipment and Utensils. (a) Equipment, Food-Contact Surfaces, and Utensils. 1. Equipment food-contact surfaces and utensils shall be clean to sight and touch. Pf. Advised PIC to burn ice and sanitizer interior of ice machine

Contamination prevented during food preparation, storage, display — Inspector Note: Observed employee drop a squeeze bottle on the floor and place it back on the prep surface without washing it. CA:(z) Miscellaneous Sources of Contamination. Food shall be protected from contamination that may result from a factor or source not specified under paragraphs (a) through (y) of this subsection. COS:PIC removed and properly washed and sanitized the bottle.

Wiping cloths: properly used and stored — Inspector Note: Observed sanitizer buckets below 200-400 ppmm quat. CA:(m) Wiping Cloths, Use Limitation. 1. Cloths in-use for wiping food spills from tableware and carry-out containers that occur as food is being served shall be: (i) Maintained dry; and (ii) Used for no other purpose. 2. Cloths in-use for wiping counters and other equipment surfaces shall be: (i) Held between uses in a chemical sanitizer solution at a concentration specified under DPH Rule 511-6-1-.05(6)(n); and (ii) Laundered daily. 3. Cloths in-use for wiping surfaces in contact with raw animal foods shall be kept separate from cloths used for other purposes. 4. Dry wiping cloths and the chemical sanitizing solutions in which wet wiping cloths are held between uses shall be free of food debris and visible soil. 5. Containers of chemical sanitizing solutions in which wet wiping cloths are held between uses shall be stored off the floor and used in a manner that prevents contamination of food, equipment, utensils, linens, single-service, or single-use articles. 6. Single-use disposable sanitizer wipes shall be used in accordance with EPA-approved manufacturer’s label use instructions. COS: PIC changed out sanitizer bucket to one with a concentration of 200 ppm quat

Warewashing facilities: installed, maintained, used; test strips — Inspector Note: Observed incorrect test strip being used to test sanitizer. CA:(h) Temperature Measuring Devices, Manual and Mechanical Warewashing. 1. In manual warewashing operations, a temperature measuring device shall be provided and readily accessible for frequently measuring the washing and sanitizing temperatures. Pf 2. In hot water mechanical warewashing operations, an irreversible registering temperature indicator shall be provided and readily accessible for measuring the utensil surface temperature. Pf (i) Sanitizing Solutions, Testing Devices. A test kit or other device that accurately measures the concentration in mg/L of sanitizing solutions shall be provided. Pf j) Cleaning Agents and Sanitizers. 1. Cleaning agents that are used to clean equipment and utensils as specified under section (7) of this Rule, shall be provided and available for use during all hours of operation. Pf 2. Except for those that are generated on-site at the time of use, chemical sanitizers that are used to sanitize equipment and utensils, as specified under Section (8) of this Rule, shall be provided and available for use during all hours of operation. Pf Advised PIC to purchase appropriate Quat test strips within 10 calendar days.

Hands clean and properly washed — Inspector Note: Observed an employee drop a bottle of oil on the floor, pick it up and continue cooking on the grill without washing their hands. CA:1. Food employees shall clean their hands and exposed portions of their arms immediately before engaging in food preparation including working with exposed food, clean equipment and utensils, and unwrapped single-service and single-use articles P and: (i) After touching bare human body parts other than clean hands and clean, exposed arms; P (ii) After using the toilet room; P (iii) After caring for or handling service animals or aquatic animals; P (iv) After coughing, sneezing, using a handkerchief or disposable tissue, using tobacco products or electronic devices that simulate tobacco smoking, eating or drinking, except for drinking from a closed beverage container and the container is handled to prevent contamination of the hands;P (v) After handling soiled equipment or utensils; P (vi) During food preparation, as often as necessary to remove soil and contamination and to prevent cross contamination when changing tasks; P (vii) When switching between working with raw food and working with ready-to-eat food; P (viii) Before donning gloves to initiate a task that involves working with food; P and (ix) After engaging in other activities that contaminate the hands. P 2. All employees shall wash hands before leaving the restroom. All food employees leaving the restroom shall wash their hands again upon re-entering the food preparation area. P Advised PIC that employees must wash hands immediately after any contamination event to prevent cross-contamination.

Management knowledge, responsibilities, reporting — Inspector Note: PIC cannot demonstrate in a verifiable manner that food employees are/ were informed of their responsibility to report symptoms and/or illness. CA:Food employees and conditional employees are informed in a verifiable manner of their responsibility to report in accordance with the Chapter, to the person in charge, information about their health and activities as they relate to diseases that are transmissible through food; Pf and COS: PIC had multiple blank employee reporting agreement forms and had all employees sign them.