MISS GOGI

Contamination prevented during food preparation, storage, display — Inspector Note: Observed a metal container of raw meat stored directly on the floor inside the walk-in freezer. Also observed two boxes of lettuce stored directly on the floor in front of the walk-in freezer. Food Storage (C) (q) Food Storage. 1. Except as specified in paragraphs 2 and 3 of this subsection, food shall be protected from contamination by storing the food: (i) In a clean, dry location; (ii) Where it is not exposed to splash, dust, or other contamination; and (iii) At least 6 inches (15 cm) above the floor. PIC moved the metal container of meat onto a shelf inside the walk-in freezer and placed the boxes of lettuce on a plastic crate off the floor

Insects, rodents, and animals not present — Inspector Note: Observed three flies throughout the main kitchen. Controlling Pests (Pf, C) (k) Controlling Pests. The presence of insects, rodents, and other pests shall be controlled to minimize their presence on the premises by: 1. Routinely inspecting incoming shipments of food and supplies; 2. Routinely inspecting the premises for evidence of pests; 3. Using methods, if pests are found, such as trapping devices or other means of pest control as specified under subsections (6)(e), (6)(m), and (6)(n) of this Rule; Pf and 4. Eliminating harborage conditions. Discussed with the PIC the need to contact pest control to address the presence of pests.

Insects, rodents, and animals not present — Inspector Note: Observed one live roach crawling along the top of an undercounter reach-in cooler in the main kitchen. Controlling Pests (Pf, C) (k) Controlling Pests. The presence of insects, rodents, and other pests shall be controlled to minimize their presence on the premises by: 1. Routinely inspecting incoming shipments of food and supplies; 2. Routinely inspecting the premises for evidence of pests; 3. Using methods, if pests are found, such as trapping devices or other means of pest control as specified under subsections (6)(e), (6)(m), and (6)(n) of this Rule; Pf and 4. Eliminating harborage conditions. Discussed with the PIC the need to contact pest control to address the presence of pests.

Proper date marking and disposition — Inspector Note: Observed a container of cream corn in a reach-in cooler with a date mark of 1/8. Ready-To-Eat Time/Temperature Control for Safety Food, Date Marking (Pf) (g) Ready-to-Eat Time/Temperature Control for Safety Food, Date Marking 1. Except when packaging food using a reduced oxygen packaging method, and except as specified in paragraphs 5 and 6 of this subsection, refrigerated, ready-to-eat, time/temperature control for safety food prepared and held in a food establishment for more than 24 hours shall be clearly marked to indicate the date or day by which the food shall be consumed on the premises, sold, or discarded, when held at a temperature of 41°F (5°C) or below for a maximum of 7 days. The day of preparation shall be counted as Day 1. Pf 2. Except as specified in paragraphs 5 through 7 of this subsection, refrigerated, ready-to-eat, time/temperature control for safety food prepared and packaged by a food processing plant shall be clearly marked, at the time the original container is opened in a food service establishment and if the food is held for more than 24 hours, to indicate the date or day by which the food shall be consumed on the premises, sold, or discarded, when held at a temperature of 41°F (5°C) or below for a maximum of 7 days after the original container is opened. The day the original container is opened in the food service establishment shall be counted as Day 1, except, the day or date marked by the food service establishment may not exceed a manufacturer’s use by date if the manufacturer determined the use-by date based on food safety; Pf 3. A refrigerated, ready-to-eat, time/temperature control for safety food ingredient or a portion of a refrigerated, ready-to-eat, time/temperature control for safety food that is subsequently combined with additional ingredients or portions of food shall retain the date marking of the earliest-prepared or first-prepared ingredient. Pf 4. A date marking system that meets the criteria stated in paragraphs 1 and 2 of this subsection may include: (i) Using a method approved by the Health Authority for refrigerated, ready-to-eat time / temperature control for safety food that is frequently rewrapped, such as lunchmeat or a roast, or for which date marking is impractical, such as soft serve mix or milk in a dispensing machine; (ii) Marking the date or day of preparation, with a procedure to discard the food on or before the last date or day by which the food must be consumed on the premises, sold, or discarded; (iv) Using calendar dates, days of the week, color-coded marks, or other effective marking methods, provided that the marking system is disclosed to the Health Authority upon request. PIC stated that the labels were incorrect, therefore PIC instructed food service employee to correct the dates.

Contamination prevented during food preparation, storage, display — Inspector Note: Observed buckets of wrapped pork stored directly on the floor of the walk in freezer. Food Storage (C) (q) Food Storage. 1. Except as specified in paragraphs 2 and 3 of this subsection, food shall be protected from contamination by storing the food: (i) In a clean, dry location; (ii) Where it is not exposed to splash, dust, or other contamination; and (iii) At least 6 inches (15 cm) above the floor. Food service employee lifted buckets of wrapped pork on to shelf.

Wiping cloths: properly used and stored — Inspector Note: Observed three wiping cloths used to wipe counters with visible food debris stored on the counter of the bar area. Wiping Cloths, Use Limitation (C) (m) Wiping Cloths, Use Limitation. 1. Cloths in-use for wiping food spills from tableware and carry-out containers that occur as food is being served shall be: (i) Maintained dry; and (ii) Used for no other purpose. 2. Cloths in-use for wiping counters and other equipment surfaces shall be: (i) Held between uses in a chemical sanitizer solution at a concentration specified under DPH Rule 511-6-1-.05(6)(n); and (ii) Laundered daily. 3. Cloths in-use for wiping surfaces in contact with raw animal foods shall be kept separate from cloths used for other purposes. 4. Dry wiping cloths and the chemical sanitizing solutions in which wet wiping cloths are held between uses shall be free of food debris and visible soil. PIC removed unclean wiping cloths to be laundered, and placed other wiping cloths in sanitizer bucket.

Single-use/single-service articles: properly stored, used — Inspector Note: Observed wrapped pork stored inside single-use buckets previously intended for soy sauce. Prohibitions; Single Service and Single Use Articles (C) 1. Except as specified in paragraph 2. of this subsection, cleaned and sanitized equipment, utensils, laundered linens, and single-service and single-use articles may not be located: (i) In locker rooms; (ii) In toilet rooms; Pf (iii) In garbage rooms; (iv) Under sewer lines that are not shielded to intercept potential drips; (v) Under leaking waterlines including leaking automatic fire sprinkler heads or underlines on which water has condensed; or (vii) Under open stairwells. (viii) Under other sources of contamination Discussed with PIC to obtain food and relocate wrapped pork to food grade containers.

Nonfood-contact surfaces clean — Inspector Note: Observed unclean blender stored on top of rolling cart in front of the ice bin. Equipment, Food/Nonfood-Contact Surfaces, and Utensils, food-contact surfaces of cooking equipment & nonfood-contact surfaces free of accumulations (C) 2. The food-contact surfaces of cooking equipment and pans shall be kept free of encrusted grease deposits and other soil accumulations. 3. Nonfood-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris. Food service employee removed blender from cart to be cleaned.

Insects, rodents, and animals not present — Inspector Note: Observed gaps that allow sunlight through, below the exit door of the main kitchen. Outer Openings Protected (C) (m) Outer Openings, Protected. 1. Except as specified in paragraphs 2 through 5 of this subsection, outer openings of a food service establishment shall be protected against the entry of insects and rodents by: (i) Filling or closing holes and other gaps along floors, walls, and ceilings; (ii) Closed, tight-fitting windows; and (iii) Solid, self-closing, tight-fitting doors. 2. The requirements in paragraph 1 of this subsection does not apply if a food service establishment opens into a larger structure, such as a mall, airport, or office building, or into an attached structure, such as a porch, and the outer openings from the larger or attached structure are protected against the entry of insects and rodents. 3. Exterior doors used as exits need not be self-closing if they are: (i) Solid and tight-fitting; (ii) Designated for use only when an emergency exists, by the fire protection authority that has jurisdiction over the food establishment; and (iii) Limited-use so they are not used for entrance or exit from the building for purposes other than the designated emergency exit use. Discussed with PIC to seal gaps of the exit door to ensure pests do not enter.

Food stored covered — Inspector Note: Observed two bins of kimchi and tofu stored uncovered inside of the reach in cooler. Packaged & Unpackaged Food, food stored covered(C) (iv) Except as specified under paragraph 2. of this subsection and when cooling as specified in DPH Rule 511-6-1-.04(6)(e)2.(ii), storing the food in packages, covered containers, or wrappings, except for loosely covered or uncovered containers in which food is being cooled if protected from overhead contamination; Food service employee placed lids on the uncovered foods.

Food-contact surfaces: cleaned & sanitized — Inspector Note: Observed black organic matter lining the inside roof of the ice machine. Equipment, Food-Contact Surfaces,& Utensils (Pf) (7) Cleaning of Equipment and Utensils. (a) Equipment, Food-Contact Surfaces, and Utensils. 1. Equipment food-contact surfaces and utensils shall be clean to sight and touch. Pf. PIC instructed food service employees to burn/discard ice, clean and sanitize ice machine before refilling with ice.

Proper hot holding temperatures — Inspector Note: Observed small container of rice hot held in warmer cabinet with a temperature of 93 degrees Fahrenheit. Time/Temperature Control for Safety; Hot Holding (P) (f) Time/Temperature Control for Safety Food, Hot and Cold Holding. Except during preparation, cooking, or cooling, or when time is used as the public health control, time/temperature control for safety food shall be maintained at 41°F (5°C) or below or 135°F (57°C) or above, except that roasts cooked to a temperature and for a time specified in subsection (5)(a)2 of this Rule and reheated using the same temperature and time conditions as cooking may be held at a temperature of 130°F (54°C) or above. P PIC voluntarily discarded rice and increased warmer cabinet temperature. Discussed with PIC, that when hot holding TCS foods, the temperature should be a minimum of 135 degrees Fahreneheit or 57 degrees Celsius.