WINGO

Nonfood-contact surfaces clean — Inspector Note: Observed gaskets on walk in cooler and prep top cooler doors unclean with black substance build up on cooler door. Advised to have deep cleaned and increase cleaning frequency. C/A: 511-6-1.05(7)(d) - Nonfood-Contact Surfaces (C) (d) Nonfood-Contact Surfaces. Nonfood-contact surfaces of equipment shall be cleaned at a frequency necessary to preclude accumulation of soil residues.

Physical facilities installed, maintained, and clean — Inspector Note: Observed floors under equipment unclean with debris build up. Advised to have deep cleaned and increase cleaning frequency. C/A: 511-6-1.07(5)(a),(b) - Good Repair, physical facilities maintained; Cleaning, Frequency & Restrictions, cleaned often enough to keep them clean (C) (5) Maintenance and Operation. (a) Good Repair. All physical facilities shall be maintained in good repair. (b) Cleaning, Frequency and Restrictions. 1. The physical facilities shall be cleaned as often as necessary to keep them clean and by methods that prevent contamination of food products. 2. Except for cleaning that is necessary due to a spill or other accident, cleaning shall be done during periods when the least amount of food is exposed, such as after closing.

Food-contact surfaces: cleaned & sanitized — Inspector Note: Observed inside of ice machine with heavy black substance build up in direct contact with ice. Observed soda machine nozzles unclean with black substance build up in direct contact with sodas. COS: Nozzles were removed and cleaned while inspector was onsite. Ice was burned and machine was cleaned while inspector was onsite. C/A: 511-6-1.05(7)(b) - Food Contact Surfaces and Utensils - Cleaning Frequency (P, C) (b) Equipment Food-Contact Surfaces and Utensils. 5. Except when dry cleaning methods are used as specified under subsection (7)(e) of this Rule, surfaces of utensils and equipment contacting food that is not time/temperature control for safety food shall be cleaned: (i) At any time when contamination may have occurred; (ii) At least every 24 hours for iced tea dispensers including nozzles and consumer self-service utensils such as tongs, scoops, or ladles; (iii) Before restocking consumer self-service equipment and utensils such as condiment dispensers and display containers; and (iv) In equipment such as ice bins and beverage dispensing nozzles and enclosed components of equipment such as ice makers, cooking oil storage tanks and distribution lines, beverage and syrup dispensing lines or tubes, coffee bean grinders, and water vending equipment: (I) At a frequency specified by the manufacturer; or (II) Absent manufacturer specifications, at a frequency necessary to preclude accumulation of soil or mold. COS: Nozzles were removed and cleaned while inspector was onsite. Ice was burned and machine was cleaned while inspector was onsite.