THE POOL TURTLE

Adequate handwashing facilities supplied & accessible — Inspector Note: Observed no paper towels at hand sink. COS: Paper towels were restocked. C/A: 511-6-1.07(3)(b) - Hand Drying Provision (Pf) (b) Hand Drying Provision. Each handwashing sink or group of adjacent handwashing sinks shall be provided with: 1. Individual, disposable towels; Pf

Toxic substances properly identified, stored, used — Inspector Note: Observed the sanitizer at the 3 compartment sink reading 400+ ppm Quats. COS: sanitizer sink was remade to read 200 ppm Quats. Advised to use test strips while preparing solutions. C/A: 511-6-1.07(6)(g) - Chemical Sanitizers, Criteria (P) (g) Chemical Sanitizers, Criteria. Chemical sanitizers, including chemical sanitizing solutions generated on-site, and other chemical antimicrobials applied to food-contact surfaces shall: 1. Meet requirements specified in 40 CFR 180.940 Tolerance exemptions for active and inert ingredients for use in antimicrobial formulations (Food-contact surface sanitizing solutions) P, or 2. Meet the requirements as specified in 40 CFR 180.2020 Pesticide Chemicals Not Requiring a Tolerance or Exemption from Tolerance-Non-food determinations. P

Food and nonfood-contact surfaces cleanable, properly designed, constructed, and used — Inspector Note: Observed cardboard lining shelves in the dry storage area. Advised PIC cardboard shall be removed. C/A: 511-6-1.05(1)(a) - Materials, General Requirements (P, C) (1) Materials. (a) General Requirements. Utensils and food-contact surfaces of equipment shall be made of materials that do not allow the migration of deleterious substances or impart colors, odors, or tastes to food and under normal use conditions, and shall be: P safe P, durable, corrosion-resistant, and nonabsorbent. In addition, materials shall be sufficient in weight and thickness to withstand repeated warewashing and shall be finished to have a smooth, easily cleanable surface. Materials shall be resistant to pitting, chipping, crazing, scratching, scoring, distortion and decomposition.

Nonfood-contact surfaces clean — Inspector Note: Observed inside of the reach in cooler unclean with food debris build up in the bottom and outside. Advised to increase cleaning frequency. C/A:511-6-1.05(7)(d) - Nonfood-Contact Surfaces (C) (d) Nonfood-Contact Surfaces. Nonfood-contact surfaces of equipment shall be cleaned at a frequency necessary to preclude accumulation of soil residues.

Physical facilities installed, maintained, and clean — Inspector Note: Observed floors under storage rack, 3 compartment sink and near mop sink in main kitchen unclean with debris build up. Advised to have deep cleaned and increase cleaning frequency. C/A: 511-6-1.07(5)(a),(b) - Good Repair, physical facilities maintained; Cleaning, Frequency & Restrictions, cleaned often enough to keep them clean (C) (5) Maintenance and Operation. (a) Good Repair. All physical facilities shall be maintained in good repair. (b) Cleaning, Frequency and Restrictions. 1. The physical facilities shall be cleaned as often as necessary to keep them clean and by methods that prevent contamination of food products. 2. Except for cleaning that is necessary due to a spill or other accident, cleaning shall be done during periods when the least amount of food is exposed, such as after closing.

No bare hand contact with ready-to-eat foods or approved alternate method properly followed — Inspector Note: Observed employee behind the bar cutting lemons with bare hands. COS: Lemons were discarded, hands were washed and gloves with put on before returning to work. C/A:511-6-1.04(4)(a)1,2,3,4(i) - Preventing Contamination from Hands (P), (Pf), (C) (4) Protection From Contamination After Receiving. (a) Preventing Contamination from Hands. 1. Food employees shall wash their hands as specified under DPH Rule 511-6-1-.03(5). 2. Except when washing fruits and vegetables or as specified under subsection (a)4, food employees shall not contact exposed, ready-to-eat food with their bare hands and shall use suitable utensils such as deli tissue, spatulas, tongs, single-use gloves, or dispensing equipment. P 3. Food employees shall minimize bare hand and arm contact with exposed food that is not in a ready- to-eat form. Pf 4. Paragraph (a)2. of this subsection does not apply to a food employee that contacts exposed, ready-to eat food with bare hands at the time the ready-to-eat food is being added as an ingredient to a food that: (i) contains a raw animal food and is to be cooked in the food service establishment to heat all parts of the food to at least the minimum time/temperatures specified in DPH Rule 511-6-1-.04(5)(a)1 and 2 and DPH Rule 511-6-1-.04(5)(b); P

Food separated and protected — Inspector Note: Observed raw cut steak stored directly next to ready to eat TCS foods (salsa& banana ketchup) stored in the 3 door reach in cooler. COS: Raw steak was discarded by PIC. Sauces were discarded by PIC. C/A: 511-6-1.04(4)(c)1(i)(ii)(iii)(v)(vi)(vii)(viii) - Packaged & Unpackaged Food Separation, Packaging, and Segregation (P, C) (c) Packaged and Unpackaged Food - Separation, Packaging, and Segregation. 1. Food shall be protected from cross contamination by: (i) Except as specified in paragraph (i)(IV) of this subsection, separating raw animal foods during storage, preparation, holding, and display from: (I) Raw ready-to-eat food including other raw animal food such as fish for sushi or molluscan shellfish, or other raw ready-to-eat food such as fruits and vegetables, P and (II) Cooked ready-to-eat food; and P (III) Fruits and vegetables before they are washed; P (IV) Frozen, commercially processed and packaged raw animal food may be stored or displayed with or above frozen, commercially processed and packaged, ready-to-eat food. (ii) Except when combined as ingredients, separating types of raw animal foods from each other such as beef, fish, lamb, pork, and poultry during storage, preparation, holding, and display by: (I) Using separate equipment for each type, P or (II) Arranging each type of food in equipment so that cross contamination of one type with another is prevented, P and (III) Preparing each type of food at different times or in separate areas; P (iii) Cleaning and sanitizing equipment and utensils; (v) Cleaning hermetically sealed containers of food of visible soil before opening; (vi) Protecting food containers that are received packaged together in a case or overwrap from cuts when the case or overwrap is opened; (vii) Storing damaged, spoiled, or recalled food being held in the food service establishment separate from food, equipment, utensils, linens and single-service and single-use articles; or (viii) Separating fruits and vegetables, before they are washed from ready-to-eat food.

Food-contact surfaces: cleaned & sanitized — Inspector Note: Observed soda nozzles behind the bar unclean with brown residue build up. COS: soda nozzles were cleaned and sanitized before placing back in use. Advised to increase the deep cleaning for nozzles. Nozzles shall be cleaned every night to prevent build. C/A: 511-6-1.05(7)(b) - Food Contact Surfaces and Utensils - Cleaning Frequency (P, C) (b) Equipment Food-Contact Surfaces and Utensils. 5. Except when dry cleaning methods are used as specified under subsection (7)(e) of this Rule, surfaces of utensils and equipment contacting food that is not time/temperature control for safety food shall be cleaned: (i) At any time when contamination may have occurred; (ii) At least every 24 hours for iced tea dispensers including nozzles and consumer self-service utensils such as tongs, scoops, or ladles; (iii) Before restocking consumer self-service equipment and utensils such as condiment dispensers and display containers; and (iv) In equipment such as ice bins and beverage dispensing nozzles and enclosed components of equipment such as ice makers, cooking oil storage tanks and distribution lines, beverage and syrup dispensing lines or tubes, coffee bean grinders, and water vending equipment: (I) At a frequency specified by the manufacturer; or (II) Absent manufacturer specifications, at a frequency necessary to preclude accumulation of soil or mold.

Toxic substances properly identified, stored, used — Inspector Note: Observed the sanitizer at the 3 compartment sink reading 400+ ppm Quats. COS: sanitizer sink was remade to read 200 ppm Quats. Advised to use test strips while preparing solutions. C/A: 511-6-1.07(6)(g) - Chemical Sanitizers, Criteria (P) (g) Chemical Sanitizers, Criteria. Chemical sanitizers, including chemical sanitizing solutions generated on-site, and other chemical antimicrobials applied to food-contact surfaces shall: 1. Meet requirements specified in 40 CFR 180.940 Tolerance exemptions for active and inert ingredients for use in antimicrobial formulations (Food-contact surface sanitizing solutions) P, or 2. Meet the requirements as specified in 40 CFR 180.2020 Pesticide Chemicals Not Requiring a Tolerance or Exemption from Tolerance-Non-food determinations. P

Contamination prevented during food preparation, storage, display — Inspector Note: OBSERVATION: No splash guard provided for hand sink. CA: 511-6-1.04(4)(t) - Food Preparation (C) (t) Food Preparation. During preparation, unpackaged food shall be protected from environmental sources of contamination. Advised to have repaired

Warewashing facilities: installed, maintained, used; test strips — Inspector Note: OBSERVATION: No maximum registering thermometer provided for the high temperature dishmachine. CA: In hot water mechanical warewashing operations, an irreversible registering temperature indicator shall be provided and readily accessible for measuring the utensil surface temperature. Advised to obtain.

Plumbing installed; proper backflow devices — Inspector Note: BSERVATION: Direct connection between the ice machine and the floor drain. CA: An air gap between the water supply inlet and the flood level rim of the plumbing fixture, equipment or nonfood equipment shall be at least twice the diameter of the water supply inlet and may not be less than 1 inch (25 mm). Advised to have repaired.

Physical facilities installed, maintained, and clean — Inspector Note: OBSERVATION: Coving is not provided in the dry storage room (single service items, canned goods, chemicals etc..) CA: 511-6-1.07(2)(c) - Floor and Wall Junctures, Coved, & Enclosed or Sealed, water-flushed floors provided with drains & graded to drain (C) (c) Floor and Wall Junctures, Coved, and Enclosed or Sealed. 1. In food service establishments in which cleaning methods other than water flushing are used for cleaning floors, the floor and wall junctures shall be coved and closed to no larger than one thirty-second inch (1 mm). Advised to have repaired