Apresdiem

Food and nonfood-contact surfaces cleanable, properly designed, constructed, and used — Inspector Note: Observed multiple cutting boards including the preptop cooler cutting boards stained and with gashes. CA- cutting boards shall be replaced or resurfaced. 511-6-1.05(6)(b) - Cutting Surfaces (C) (b) Cutting Surfaces. Surfaces such as cutting blocks and boards that are subject to scratching and scoring shall be resurfaced if they can no longer be effectively cleaned and sanitized, or discarded if they cannot be resurfaced.

Nonfood-contact surfaces clean — Inspector Note: Observed rusted shelves in the WIc. CA- shelves shall be maintained in good condition. 511-6-1.05(7)(a)2,3 - Equipment, Food/Nonfood-Contact Surfaces, and Utensils, food-contact surfaces of cooking equipment & nonfood-contact surfaces free of accumulations (C) 2. The food-contact surfaces of cooking equipment and pans shall be kept free of encrusted grease deposits and other soil accumulations. 3. Nonfood-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris.

Adequate handwashing facilities supplied & accessible — Inspector Note: Obseved ice dumped in the designated hand sink at the time of the inspection. CA- hand sink may not be used for any other purposes other than hand washing. 511-6-1.06(2)(o) - Using a Handwashing Sink- Operation & maintenance (Pf) (o) Using a Handwashing Sink. 1. A handwashing sink shall be maintained so that it is accessible at all times for employee use. Pf 2. A handwashing facility may not be used for purposes other than handwashing. Pf

Approved thawing methods used — Inspector Note: Observed raw tuna thawing in the Vacuum packaging with a warning label. COS- tuna was removed from packaging. 511-6-1.04(6)(c) - Thawing (C) (c) Thawing. Except as specified in paragraph 4 of this subsection, time/temperature control for safety food shall be thawed: 5. Reduced oxygen packaged fish that bears a label indicating that it is to be kept frozen until time of use shall be removed from the reduced oxygen environment: (i) Prior to its thawing under refrigeration that maintains the food temperature at 41°F (5°C) or less; or (ii) Prior to, or immediately upon completion of its thawing, using procedures to completely submerge in running water as specified in paragraph 2 of this subsection.

In-use utensils: properly stored — Inspector Note: Observed scoops stored with the handles down in sugar and rice. COS- scoops were moved with their handles above. 511-6-1.04(4)(k) - In-Use Utensils, Between-Use Storage (C) (k)Storage of In-Use Utensils. During pauses in food preparation or dispensing, food preparation and dispensing utensils shall be stored: 1.Except as specified under paragraph 2 of this subsection, in the food with their handles above the top of the food and the container;

Food and nonfood-contact surfaces cleanable, properly designed, constructed, and used — Inspector Note: Observed multiple cutting boards including the preptop cooler cutting boards stained and with gashes. CA- cutting boards shall be replaced or resurfaced. 511-6-1.05(6)(b) - Cutting Surfaces (C) (b) Cutting Surfaces. Surfaces such as cutting blocks and boards that are subject to scratching and scoring shall be resurfaced if they can no longer be effectively cleaned and sanitized, or discarded if they cannot be resurfaced.

Food and nonfood-contact surfaces cleanable, properly designed, constructed, and used — Inspector Note: Observed the ambient temperature of a preptop cooler at 47 degrees F, the facility already had food on ice on the top. The thermometer inside the cooler was reading at 10 degrees F. CA- PIC called someone to repair the cooler and will continue to keep the food on ice. 511-6-1.05(6)(q)1&3 - Good Repair & Calibration (C) (q) Good Repair and Calibration. 1. Utensils shall be maintained in a state of repair or condition that complies with the requirements specified under subsections (1) and (2) of this Rule or shall be discarded. 3. Ambient air temperature, water pressure, and water temperature measuring devices shall be maintained in good repair and be accurate within the intended range of use.