H.J.C. Bowden Senior Multipurpose Facility

Single-use/single-service articles: properly stored, used — Inspector Note: Observed sleeves of styrofoam to-go containers stored on floor behind front counter food service line in kitchen. CA: Operator removed from floor and stored on shelf during inspection. 511-6-1.05(10)(e)1&3 - Single-Service/Single-Use items stored 6" off floor in clean, dry location (C) (e) Equipment, Utensils, Linens, and Single-Service and Single-Use Articles. 1. Except as specified in paragraph 4 of this subsection, cleaned equipment and utensils, laundered linens, and single-service and single-use articles shall be stored: (i) In a clean, dry location; (ii) Where they are not exposed to splash, dust, or other contamination; and (iii) At least 6 inches (15 centimeters) above the floor. 3. Single-service and single-use articles shall be stored as specified under paragraph 1 of this subsection and shall be kept in the original protective package or stored by using other means that afford protection from contamination until used.

Hot and cold water available; adequate pressure — Inspector Note: Observed lack of hot water provided at HWS next to dish machine in kitchen. CA: Kitchen manager placed work order for maintenance team to service sink during inspection. 511-6-1.06(1)(g),(h) - Water Supply, Capacity; Pressure (Pf) (g) Capacity. 1. The water source and system shall be of sufficient capacity to meet the peak water demands of the food service establishment. Pf 2. Hot water generation and distribution systems shall be sufficient to meet the peak hot water demands throughout the food service establishment. Pf (h) Pressure. Water under pressure shall be provided to all fixtures, equipment, and nonfood equipment that are required to use water except that water supplied as specified under subsection (1)(k)1 and 2 to a temporary food service operation or in response to a temporary interruption of a water supply need not be under pressure. Pf

Food properly labeled; original container — Inspector Note: Observed plastic bottles holding butter no label on food prep table and shelves in kitchen. Observed plastic container holding chicken seasoning no label in kitchen. Observed plastic container holding paprika flour no label in kitchen. Operator labeled all plastic bottles and containers during inspection. 511-6-1.04(4)(d) - Food Storage Containers Identified with Common Name of Food (C) (d) Food Storage Containers, Identified with Common Name of Food. Except for containers holding food that can be readily and unmistakably recognized, such as dry pasta, working containers holding food or food ingredients that are removed from their original packages for use in the food establishment, such as cooking oils, flour, herbs, potato flakes, salt, spices, and sugar shall be clearly and legibly identified, in English, with the common name of the food.

Contamination prevented during food preparation, storage, display — Inspector Note: Observed container of cooking oil stored on floor underneath prep table in kitchen. Operator removed oil from floor during inspection. 511-6-1.04(4)(q) - Food Storage (C) (q) Food Storage. 1. Except as specified in paragraphs 2 and 3 of this subsection, food shall be protected from contamination by storing the food: (i) In a clean, dry location; (ii) Where it is not exposed to splash, dust, or other contamination; and (iii) At least 6 inches (15 cm) above the floor.

Warewashing facilities: installed, maintained, used; test strips — Inspector Note: Observed chemical dish machine sanitizer 0 ppm during inspection. Operator placed maintenance service work order during inspection. 511-6-1.05(2)(cc) - Warewashing, Automatic Dispensing of Detergents and Sanitizers (Pf) (cc) Warewashing Machines, Automatic Dispensing of Detergents and Sanitizers. A warewashing machine that is installed after September 12, 2007 shall be designed and equipped to: automatically dispense detergents and sanitizers Pf and incorporate a visual means to verify that detergents and sanitizers are delivered or a visual or audible alarm to signal if the detergents and sanitizers are not delivered to the respective washing and sanitizing cycles. Pf

Proper cooling time and temperature — Inspector Note: Observed cooked baked beans 47 F, potato salad 52 F and broccoli 49 F prepared on 2/20/2026 holding on shelf and speed cart in walk in cooler with kitchen. Operator discarded all TCS foods at time of inspection. 511-6-1.04(6)(d) - Cooling (P) (d) Cooling. 1. Cooked time/temperature control for safety food shall be cooled: (i) Within 2 hours from 135°F (57°C) to 70°F (21°C); P and (ii) Within a total of 6 hours from 135°F (57°C) to 41°F (5°C) or less. P

Proper date marking and disposition — Inspector Note: Observed cooked sausage patties held on speed cart in walk in cooler without date label in kitchen. Operator discarded sausage patties during inspection. 511-6-1.04(6)(g) - Ready-To-Eat Time/Temperature Control for Safety Food, Date Marking (Pf) (g) Ready-to-Eat Time/Temperature Control for Safety Food, Date Marking 1. Except when packaging food using a reduced oxygen packaging method, and except as specified in paragraphs 5 and 6 of this subsection, refrigerated, ready-to-eat, time/temperature control for safety food prepared and held in a food establishment for more than 24 hours shall be clearly marked to indicate the date or day by which the food shall be consumed on the premises, sold, or discarded, when held at a temperature of 41°F (5°C) or below for a maximum of 7 days. The day of preparation shall be counted as Day 1. Pf 2. Except as specified in paragraphs 5 through 7 of this subsection, refrigerated, ready-to-eat, time/temperature control for safety food prepared and packaged by a food processing plant shall be clearly marked, at the time the original container is opened in a food service establishment and if the food is held for more than 24 hours, to indicate the date or day by which the food shall be consumed on the premises, sold, or discarded, when held at a temperature of 41°F (5°C) or below for a maximum of 7 days after the original container is opened. The day the original container is opened in the food service establishment shall be counted as Day 1, except, the day or date marked by the food service establishment may not exceed a manufacturer’s use by date if the manufacturer determined the use-by date based on food safety; Pf 3. A refrigerated, ready-to-eat, time/temperature control for safety food ingredient or a portion of a refrigerated, ready-to-eat, time/temperature control for safety food that is subsequently combined with additional ingredients or portions of food shall retain the date marking of the earliest-prepared or first-prepared ingredient. Pf (ii) Marking the date or day of preparation, with a procedure to discard the food on or before the last date or day by which the food must be consumed on the premises, sold, or discarded; (iii) Marking the date or day the original container is opened in a food service establishment, with a procedure to discard the food on or before the last date or day by which the food must be consumed on the premises, sold, or discarded; or (iv) Using calendar dates, days of the week, color-coded marks, or other effective marking methods, provided that the marking system is disclosed to the Health Authority upon request.

Toxic substances properly identified, stored, used — Inspector Note: Observed plastic spray bottle holding degreaser stored on shelf in chemical closet not labeled. Operator labeled spray bottle during inspection. 511-6-1.07(6)(b) - Working Containers, Common Name (Pf) (b) Working Containers, Common Name. Working containers used for storing poisonous or toxic materials such as cleaners and sanitizers taken from bulk supplies shall be clearly and individually identified with the common name of the material. Pf