Olyzubbys African Restaurant

Warewashing facilities: installed, maintained, used; test strips — Inspector Note: Observed no chlorine test kit provided at time of routine inspection. Operator must provide chlorine test kit within 10 days. 511-6-1.05(3)(h),(i),(j) - Temperature Measuring Device, Manual Warewashing; Sanitizing Solutions, Testing Device (Pf) (h) Temperature Measuring Devices, Manual and Mechanical Warewashing. 1. In manual warewashing operations, a temperature measuring device shall be provided and readily accessible for frequently measuring the washing and sanitizing temperatures. Pf 2. In hot water mechanical warewashing operations, an irreversible registering temperature indicator shall be provided and readily accessible for measuring the utensil surface temperature. Pf (i) Sanitizing Solutions, Testing Devices. A test kit or other device that accurately measures the concentration in mg/L of sanitizing solutions shall be provided. Pf j) Cleaning Agents and Sanitizers. 1. Cleaning agents that are used to clean equipment and utensils as specified under section (7) of this Rule, shall be provided and available for use during all hours of operation. Pf 2. Except for those that are generated on-site at the time of use, chemical sanitizers that are used to sanitize equipment and utensils, as specified under Section (8) of this Rule, shall be provided and available for use during all hours of operation. Pf

Nonfood-contact surfaces clean — Inspector Note: Observed reach in cooler/freezer shelving soiled at time of inspection. Operator must clean/sanitize non food contact surfaces within 10 days. Observed hood filters soiled at time of inspection. 511-6-1.05(7)(d) - Nonfood-Contact Surfaces (C) (d) Nonfood-Contact Surfaces. Nonfood-contact surfaces of equipment shall be cleaned at a frequency necessary to preclude accumulation of soil residues.

Proper date marking and disposition — Inspector Note: Observed cooked rice, operator states prepared on 7/4/2026 stored on shelf in reach in cooler without proper date marking. CA: Operator provided proper date label at time of inspection. 11-6-1.04(6)(g) - Ready-To-Eat Time/Temperature Control for Safety Food, Date Marking (Pf) (g) Ready-to-Eat Time/Temperature Control for Safety Food, Date Marking 1. Except when packaging food using a reduced oxygen packaging method, and except as specified in paragraphs 5 and 6 of this subsection, refrigerated, ready-to-eat, time/temperature control for safety food prepared and held in a food establishment for more than 24 hours shall be clearly marked to indicate the date or day by which the food shall be consumed on the premises, sold, or discarded, when held at a temperature of 41°F (5°C) or below for a maximum of 7 days. The day of preparation shall be counted as Day 1. Pf

Food properly labeled; original container — Inspector Note: Working containers of food removed from original container not identified by common name. CA: Label all foods not in the original packaging within 7 days or discard. 511-6-1.04(4)(d) - Food Storage Containers Identified with Common Name of Food (C) (d) Food Storage Containers, Identified with Common Name of Food. Except for containers holding food that can be readily and unmistakably recognized, such as dry pasta, working containers holding food or food ingredients that are removed from their original packages for use in the food establishment, such as cooking oils, flour, herbs, potato flakes, salt, spices, and sugar shall be clearly and legibly identified, in English, with the common name of the food.

Single-use/single-service articles: properly stored, used — Inspector Note: Single use articles and/or single service articles are not being kept in the original protective package or are not being stored by using other means that afford protection form contamination until they are used. CA: Discard all to go single service time that are laying around the kitchen unprotected. 511-6-1.05(10)(e)1&3 - Single-Service/Single-Use items stored 6" off floor in clean, dry location (C) (e) Equipment, Utensils, Linens, and Single-Service and Single-Use Articles. 1. Except as specified in paragraph 4 of this subsection, cleaned equipment and utensils, laundered linens, and single-service and single-use articles shall be stored: (i) In a clean, dry location; (ii) Where they are not exposed to splash, dust, or other contamination; and (iii) At least 6 inches (15 centimeters) above the floor. 3. Single-service and single-use articles shall be stored as specified under paragraph 1 of this subsection and shall be kept in the original protective package or stored by using other means that afford protection from contamination until used.

Food and nonfood-contact surfaces cleanable, properly designed, constructed, and used — Inspector Note: Equipment and/or utensils in the establishment are not designed and constructed to be durable to retain their characteristic qualities under normal use conditions. CA: Remove all household reach in freezer including all the ones labeled staff only. (Which are all the freezer in the establishment).

Warewashing facilities: installed, maintained, used; test strips — Inspector Note: No chemical test kit provided when using chemical sanitizer at three-compartment sink/warewashing machine. CA: Manager/owner must obtain the correct sanitizing test strips for chlorine sanitizer within 24 hours. 511-6-1.05(2)(cc) - Warewashing, Automatic Dispensing of Detergents and Sanitizers (Pf) (cc) Warewashing Machines, Automatic Dispensing of Detergents and Sanitizers. A warewashing machine that is installed after September 12, 2007 shall be designed and equipped to: automatically dispense detergents and sanitizers Pf and incorporate a visual means to verify that detergents and sanitizers are delivered or a visual or audible alarm to signal if the detergents and sanitizers are not delivered to the respective washing and sanitizing cycles. Pf

Nonfood-contact surfaces clean — Inspector Note: Observed all cold holding units are not cleaned to prevent accumulation of soil residue. They are filthy. CA: Manager/owner must clean out all for the cold holding units including the ones labeled staff only. 511-6-1.05(7)(a)2,3 - Equipment, Food/Nonfood-Contact Surfaces, and Utensils, food-contact surfaces of cooking equipment & nonfood-contact surfaces free of accumulations (C) 2. The food-contact surfaces of cooking equipment and pans shall be kept free of encrusted grease deposits and other soil accumulations. 3. Nonfood-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris.

Nonfood-contact surfaces clean — Inspector Note: Observed interior of reach-in cooler soiled with accumulation of food residue.

Nonfood-contact surfaces clean — Inspector Note: Observed wall soiled with accumulated food debris. CA: Clean all walls throughout the facility within 7 days. 511-6-1.05(7)(d) - Nonfood-Contact Surfaces (C) (d) Nonfood-Contact Surfaces. Nonfood-contact surfaces of equipment shall be cleaned at a frequency necessary to preclude accumulation of soil residues.

Plumbing installed; proper backflow devices — Inspector Note: Observed water draining onto floor surface. When the water is turned on at the 3 compartment sink.

Physical facilities installed, maintained, and clean — Inspector Note: Ceiling not smooth and easily cleanable. Badly peeling paint on kitchen. CA: Must remove peeling paint on kitchen ceiling and re-paint or repair ceiling tiles. 511-6-1.07(5)(a),(b) - Good Repair, physical facilities maintained; Cleaning, Frequency & Restrictions, cleaned often enough to keep them clean (C) (5) Maintenance and Operation. (a) Good Repair. All physical facilities shall be maintained in good repair. (b) Cleaning, Frequency and Restrictions. 1. The physical facilities shall be cleaned as often as necessary to keep them clean and by methods that prevent contamination of food products. 2. Except for cleaning that is necessary due to a spill or other accident, cleaning shall be done during periods when the least amount of food is exposed, such as after closing. 3. If present, playground equipment and associated areas shall be maintained in a clean and sanitary condition. In addition, a cleaning and sanitizing plan along with cleaning and sanitizing records for playground equipment and associated areas shall be maintained within the food service establishment for review upon request by the Health Authority. Further, such cleaning and sanitizing plan for employees to follow in the event of encountering vomitus or fecal matter shall be included and submitted at the time of permit application as specified in DPH Rule 511-6-1-.02(1)(c). Pf

Insects, rodents, and animals not present — Inspector Note: Outer openings of establishment cannot be properly sealed when not in operation. Observed screen door not installed on hinges. Screen door leaning on rear door. CA: Properly install screen door 511-6-1.07(2)(m) - Outer Openings Protected (C) (m) Outer Openings, Protected. 1. Except as specified in paragraphs 2 through 5 of this subsection, outer openings of a food service establishment shall be protected against the entry of insects and rodents by: (i) Filling or closing holes and other gaps along floors, walls, and ceilings; (ii) Closed, tight-fitting windows; and (iii) Solid, self-closing, tight-fitting doors. 2. The requirements in paragraph 1 of this subsection does not apply if a food service establishment opens into a larger structure, such as a mall, airport, or office building, or into an attached structure, such as a porch, and the outer openings from the larger or attached structure are protected against the entry of insects and rodents. 3. Exterior doors used as exits need not be self-closing if they are: (i) Solid and tight-fitting; (ii) Designated for use only when an emergency exists, by the fire protection authority that has jurisdiction over the food establishment; and (iii) Limited-use so they are not used for entrance or exit from the building for purposes other than the designated emergency exit use. 4. Except as specified in paragraphs 2 and 5 of this subsection, if the windows or doors of a food service establishment, or of a larger structure within which a food service establishment is located, are kept open for ventilation or other purposes or a temporary food service establishment is not provided with windows and doors as specified under paragraph 1 of this subsection, the openings shall be protected against the entry of insects and rodents by: (i) 16 mesh to 1 inch (16 mesh to 25.4 mm) screens; (ii) Properly designed and installed air curtains to control flying insects; or (iii) Other effective means. 5. The requirement in paragraph 4 of this subsection does not apply if flying insects and other pests are absent due to the location of the establishment, the weather, or other limiting condition.

Food-contact surfaces: cleaned & sanitized — Inspector Note: Observed Wiping cloth stored in chlorine sanitizing solution not at proper minimum strength. Leaves reading 0. COS: I had the certified food safety manager to make up a sanitizing bucket with the proper sanitizing level. 511-6-1.05(6)(o) - Manual Warewashing Equipment, Chemical Sanitization using Detergent Sanitizers(C) (o) Manual Warewashing Equipment, Chemical Sanitization Using Detergent-Sanitizers. If a detergent-sanitizer is used to sanitize in a cleaning and sanitizing procedure where there is no distinct water rinse between the washing and sanitizing steps, the agent applied in the sanitizing step shall be the same detergent-sanitizer that is used in the washing step.

Proper date marking and disposition — Inspector Note: Observed combined ready-to-eat potentially hazardous food held more than 24 hours not date marked according to earliest date of opening/preparation. CA: manager shall date mark foods with the preparation date of discard date. Within 24 hour or discard. 511-6-1.04(6)(g) - Ready-To-Eat Time/Temperature Control for Safety Food, Date Marking (Pf) (g) Ready-to-Eat Time/Temperature Control for Safety Food, Date Marking 1. Except when packaging food using a reduced oxygen packaging method, and except as specified in paragraphs 5 and 6 of this subsection, refrigerated, ready-to-eat, time/temperature control for safety food prepared and held in a food establishment for more than 24 hours shall be clearly marked to indicate the date or day by which the food shall be consumed on the premises, sold, or discarded, when held at a temperature of 41°F (5°C) or below for a maximum of 7 days. The day of preparation shall be counted as Day 1. Pf 2. Except as specified in paragraphs 5 through 7 of this subsection, refrigerated, ready-to-eat, time/temperature control for safety food prepared and packaged by a food processing plant shall be clearly marked, at the time the original container is opened in a food service establishment and if the food is held for more than 24 hours, to indicate the date or day by which the food shall be consumed on the premises, sold, or discarded, when held at a temperature of 41°F (5°C) or below for a maximum of 7 days after the original container is opened. The day the original container is opened in the food service establishment shall be counted as Day 1, except, the day or date marked by the food service establishment may not exceed a manufacturer’s use by date if the manufacturer determined the use-by date based on food safety; Pf