Atlanta National Golf Club-Kitchen

Approved thawing methods used — Inspector Note: Observed raw tuna being thawed in vacuum sealed packaging in the reach-in cooler. PIC discarded raw tuna. 511-6-1.04(6)(c) - Thawing (C) (c) Thawing. Except as specified in paragraph 4 of this subsection, time/temperature control for safety food shall be thawed: 1. Under refrigeration that maintains the food temperature at 41°F (5°C) or less; PF or 2. Completely submerged under running water: (i) At a water temperature of 70°F (21°C) or below, PF (ii) With sufficient water velocity to agitate and float off loose particles in an overflow PF, and (iii) For a period of time that does not allow thawed portions of ready-to-eat food to rise above 41°F (5°C), or (iv) For a period of time that does not allow thawed portions of a raw animal food requiring cooking to be above 41°F (5°C), for more than 4 hours including: (I) The time the food is exposed to the running water and the time needed for preparation for cooking PF, or (II) The time it takes under refrigeration to lower the food temperature to 41°F (5°C) PF;

Warewashing facilities: installed, maintained, used; test strips — Inspector Note: Observed 3-compartment sink dispensing solution at 0 ppm. Advised PIC to have 3-compartment sink serviced immediately. 511-6-1.05(2)(cc) - Warewashing, Automatic Dispensing of Detergents and Sanitizers (Pf) (cc) Warewashing Machines, Automatic Dispensing of Detergents and Sanitizers. A warewashing machine that is installed after September 12, 2007 shall be designed and equipped to: automatically dispense detergents and sanitizers Pf and incorporate a visual means to verify that detergents and sanitizers are delivered or a visual or audible alarm to signal if the detergents and sanitizers are not delivered to the respective washing and sanitizing cycles. Pf

Adequate ventilation and lighting; designated areas used — Inspector Note: Observed multiple water bottles and cellular devices in the food preparation areas. PIC removed bottles and devices from the area. 511-6-1.07(4)(b) - Designated Areas for Employee Activity, located to prevent contamination of food, equipment, utensils, linens, & single service articles (C) (b) Designated Areas for Employee Activity. 1. Areas designated for employees to eat, drink, use tobacco products and electronic devices shall be located so that food, equipment, linens, and single-service and single-use articles are protected from contamination. 2. Lockers or other suitable facilities shall be located in a designated room or area where contamination of food, equipment, utensils, linens and single-service and single-use articles cannot occur.

Food separated and protected — Inspector Note: Observed raw bacon being stored above TCS, ready-to-eat foods. PIC removed bacon and placed it below the TCS, RTE foods. 511-6-1.04(4)(c)1(i)(ii)(iii)(v)(vi)(vii)(viii) - Packaged & Unpackaged Food Separation, Packaging, and Segregation (P, C) (c) Packaged and Unpackaged Food - Separation, Packaging, and Segregation. 1. Food shall be protected from cross contamination by: (i) Except as specified in paragraph (i)(IV) of this subsection, separating raw animal foods during storage, preparation, holding, and display from: (I) Raw ready-to-eat food including other raw animal food such as fish for sushi or molluscan shellfish, or other raw ready-to-eat food such as fruits and vegetables, P and (II) Cooked ready-to-eat food; and P (III) Fruits and vegetables before they are washed; P (IV) Frozen, commercially processed and packaged raw animal food may be stored or displayed with or above frozen, commercially processed and packaged, ready-to-eat food.

Food-contact surfaces: cleaned & sanitized — Inspector Note: Observed mold-like substance on the lip of the ice machine. Advised PIC to have ice machine cleaned and sanitized immediately. 511-6-1.05(7)(a)1 - Equipment, Food-Contact Surfaces,& Utensils (Pf) (7) Cleaning of Equipment and Utensils. (a) Equipment, Food-Contact Surfaces, and Utensils. 1. Equipment food-contact surfaces and utensils shall be clean to sight and touch. Pf.

Proper date marking and disposition — Inspector Note: Observed multiple containers with TCS foods held past seven days. PIC discarded food items. 511-6-1.04(6)(h) - Ready-To-Eat Time/Temperature Control for Safety Food, Disposition (P) (h) Ready-to-Eat, Time/Temperature Control for Safety Food, Disposition. 1. A food that requires datemarking shall be discarded if it: (i) Exceeds 7 days, not including the time that the product is frozen; P (ii) Is in a container or package that does not bear a date or day; P or (iii) Is inappropriately marked with a date or day that exceeds 7 days . P 2. Refrigerated, ready-to-eat, time / temperature control for safety food prepared in a food service establishment and dispensed through a vending machine with an automatic shutoff control shall be discarded if it exceeds 7 days. P

Proper date marking and disposition — Inspector Note: Observed multiple containers with TCS, ready to eat food items held past seven days. PIC immediately discarded. 511-6-1.04(6)(g) - Ready-To-Eat Time/Temperature Control for Safety Food, Date Marking (Pf) (g) Ready-to-Eat Time/Temperature Control for Safety Food, Date Marking 1. Except when packaging food using a reduced oxygen packaging method, and except as specified in paragraphs 5 and 6 of this subsection, refrigerated, ready-to-eat, time/temperature control for safety food prepared and held in a food establishment for more than 24 hours shall be clearly marked to indicate the date or day by which the food shall be consumed on the premises, sold, or discarded, when held at a temperature of 41°F (5°C) or below for a maximum of 7 days. The day of preparation shall be counted as Day 1. Pf 2. Except as specified in paragraphs 5 through 7 of this subsection, refrigerated, ready-to-eat, time/temperature control for safety food prepared and packaged by a food processing plant shall be clearly marked, at the time the original container is opened in a food service establishment and if the food is held for more than 24 hours, to indicate the date or day by which the food shall be consumed on the premises, sold, or discarded, when held at a temperature of 41°F (5°C) or below for a maximum of 7 days after the original container is opened. The day the original container is opened in the food service establishment shall be counted as Day 1, except, the day or date marked by the food service establishment may not exceed a manufacturer’s use by date if the manufacturer determined the use-by date based on food safety; Pf 3. A refrigerated, ready-to-eat, time/temperature control for safety food ingredient or a portion of a refrigerated, ready-to-eat, time/temperature control for safety food that is subsequently combined with additional ingredients or portions of food shall retain the date marking of the earliest-prepared or first-prepared ingredient. Pf

Food in good condition, safe, and unadulterated — Inspector Note: Observed various molded vegetables in the WIC. PIC discarded food. 511-6-1.04(1) - Safe, unadulterated and Honestly Presented (P) (1) Condition. Food shall be safe, unadulterated, and honestly presented. P

Food-contact surfaces: cleaned & sanitized — Inspector Note: Observed mold-like substance in the ice machine. Advised PIC to clean ice machine. 511-6-1.05(7)(a)1 - Equipment, Food-Contact Surfaces,& Utensils (Pf) (7) Cleaning of Equipment and Utensils. (a) Equipment, Food-Contact Surfaces, and Utensils. 1. Equipment food-contact surfaces and utensils shall be clean to sight and touch. Pf.

Proper date marking and disposition — Inspector Note: Observed multiple containers with TCS, ready-to-eat foods held past the seven day date mark. PIC discarded items and advised to hold TCS items for seven days, including the day it was made or opened.