College Park Elementary School

Proper cooling methods used: adequate equipment for temperature control — Inspector Note: Observed cooked pasta cooling in large, deep pans over ice in walk in cooler in kitchen. Person in charge placed cooked pasta in shallow pans submerged in ice to properly cool during inspection. 511-6-1.04(6)(e) - Cooling Methods (Pf, C) (e) Cooling Methods. 1. Cooling shall be accomplished in accordance with the time and temperature criteria specified under DPH Rule 511-6-1-.04(6)(d) by using one or more of the following methods depending on the type of food being cooled: (i) Placing the food in shallow pans; Pf (ii) Separating the food into smaller or thinner portions; Pf (iii) Using rapid cooling equipment; Pf (iv) Stirring the food in a container placed in an ice water bath; Pf (v) Using containers that facilitate heat transfer; Pf (vi) Adding ice as an ingredient; Pf or (vii) Other effective methods. Pf 2. When placed in cooling or cold holding equipment, food containers in which food is being cooled shall be: (i) Arranged in the equipment to provide maximum heat transfer through the container walls; and (ii) Loosely covered, or uncovered if protected from overhead contamination during the cooling period to facilitate heat transfer from the surface of the food.

Food and nonfood-contact surfaces cleanable, properly designed, constructed, and used — Inspector Note: Observed inner plastic panel within ice bin soiled with debris like substance. Operator provided work order form placed for proper cleaning/sanitization of ice bin. 511-6-1.05(1)(i) - Nonfood-contact Surfaces (C) (i) Nonfood-contact Surfaces. Nonfood-contact surfaces of equipment that are exposed to splash, spillage, or other food soiling or that require frequent cleaning shall be constructed of a corrosion-resistant, nonabsorbent, and smooth material.

Nonfood-contact surfaces clean — Inspector Note: Observed residue on inner drawer handles at prep tables in kitchen. Operator cleaned and sanitized drawer handles during inspection. 511-6-1.05(7)(d) - Nonfood-Contact Surfaces (C) (d) Nonfood-Contact Surfaces. Nonfood-contact surfaces of equipment shall be cleaned at a frequency necessary to preclude accumulation of soil residues.

Plumbing installed; proper backflow devices — Inspector Note: Observed water dripping from pipe line underneath three compartment sink in kitchen. Operator provided work order form placed for leaking sink during inspection. Violation must be rectified by next routine inspection. 511-6-1.06(2)(r) - System Maintained in Good Repair (P, C) (r) System Maintained in Good Repair. A plumbing system shall be repaired according to law; P and maintained in good repair.