11 Dining LLC

Proper cooling methods used: adequate equipment for temperature control — Inspector Note: Observed tuna taken from the can cooling improperly inside a RIC. Observed the tuna tightly wrapped and not in a shallow container. COS- tuna was moved to a sheet pan and loosely covered. 511-6-1.04(6)(e) - Cooling Methods (Pf, C) (e) Cooling Methods. 1. Cooling shall be accomplished in accordance with the time and temperature criteria specified under DPH Rule 511-6-1-.04(6)(d) by using one or more of the following methods depending on the type of food being cooled: (i) Placing the food in shallow pans; Pf (ii) Separating the food into smaller or thinner portions; Pf (iii) Using rapid cooling equipment; Pf (iv) Stirring the food in a container placed in an ice water bath; Pf (v) Using containers that facilitate heat transfer; Pf (vi) Adding ice as an ingredient; Pf or (vii) Other effective methods. Pf 2. When placed in cooling or cold holding equipment, food containers in which food is being cooled shall be: (i) Arranged in the equipment to provide maximum heat transfer through the container walls; and (ii) Loosely covered, or uncovered if protected from overhead contamination during the cooling period to facilitate heat transfer from the surface of the food.

Utensils, equipment and linens: properly stored, dried, handled — Inspector Note: Observed dishes stacked wet. COS- Dishes were unstacked to finish air drying. 511-6-1.05(10)(a) - Equipment & Utensils, Air-Drying Required (C) (10) Protection of Clean Items. (a) Equipment and Utensils, Air-Drying Required. After cleaning and sanitizing, equipment and utensils: 1. Shall be air-dried or used after adequate draining before contact with food; and 2. May not be cloth dried except that utensils that have been air-dried may be polished with cloths that are maintained clean and dry.

Utensils, equipment and linens: properly stored, dried, handled — Inspector Note: Observed dishes stacked wet. COS- Dishes were unstacked to finish air drying. 511-6-1.05(10)(a) - Equipment & Utensils, Air-Drying Required (C) (10) Protection of Clean Items. (a) Equipment and Utensils, Air-Drying Required. After cleaning and sanitizing, equipment and utensils: 1. Shall be air-dried or used after adequate draining before contact with food; and 2. May not be cloth dried except that utensils that have been air-dried may be polished with cloths that are maintained clean and dry.

Nonfood-contact surfaces clean — Inspector Note: Obserevd the cooler gaskets unclean at the time of the inspection. CA- gaskets shall be kept clean and free of debris. Observed the freezer in the coffee area unclean. CA- coffee freezer shall be cleaned and free of debris. 511-6-1.05(7)(a)2,3 - Equipment, Food/Nonfood-Contact Surfaces, and Utensils, food-contact surfaces of cooking equipment & nonfood-contact surfaces free of accumulations (C) 2. The food-contact surfaces of cooking equipment and pans shall be kept free of encrusted grease deposits and other soil accumulations. 3. Nonfood-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris.

Food-contact surfaces: cleaned & sanitized — Inspector Note: Observed in one of the ice machines the interior flap with pink buildup at the time of the inspection. COS- ice machine that is unclean will not be used until cleaned. 511-6-1.05(7)(b) - Food Contact Surfaces and Utensils - Cleaning Frequency (P, C) (b) Equipment Food-Contact Surfaces and Utensils. 1. Equipment food-contact surfaces and utensils shall be cleaned: iv) In equipment such as ice bins and beverage dispensing nozzles and enclosed components of equipment such as ice makers, cooking oil storage tanks and distribution lines, beverage and syrup dispensing lines or tubes, coffee bean grinders, and water vending equipment: (I) At a frequency specified by the manufacturer; or (II) Absent manufacturer specifications, at a frequency necessary to preclude accumulation of soil or mold.