Chick-N-Run

Posted: Permit/Inspection/Choking Poster/Handwashing — Inspector Note: Observed no permit posted within the facility. 511-6-1.02(1)(f)(1) - Permit, Displayed (C) 1. Post the permit in a location in the food service establishment that is conspicuous to consumers

Food and nonfood-contact surfaces cleanable, properly designed, constructed, and used — Inspector Note: Observed cardboard being used as a splash guard for drink machine. 511-6-1.05(1)(i) - Nonfood-contact Surfaces (C) (i) Nonfood-contact Surfaces. Nonfood-contact surfaces of equipment that are exposed to splash, spillage, or other food soiling or that require frequent cleaning shall be constructed of a corrosion-resistant, nonabsorbent, and smooth material.

Food and nonfood-contact surfaces cleanable, properly designed, constructed, and used — Inspector Note: Observed evidence of leaking fryers; bowls were placed under fryer to catch grease. 511-6-1.05(6)(a) - Good Repair & Proper Adjustment (C) (6) Maintenance and Operation. (a) Good Repair and Proper Adjustment. 1. Equipment shall be maintained in a state of repair and condition that meets the requirements specified under subsections (1) and (2)of this Rule. 2. Equipment components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturer's specifications. 3. Cutting or piercing parts of can openers shall be kept sharp to minimize the creation of metal fragments that can contaminate food when the container is opened.

Nonfood-contact surfaces clean — Inspector Note: Observed water accumulation on the reach-in cooler floor. Also observed rusting and food debris on shelving units in walk-in cooler and rusting on shelving units holding clean equipment. 511-6-1.05(7)(a)2,3 - Equipment, Food/Nonfood-Contact Surfaces, and Utensils, food-contact surfaces of cooking equipment & nonfood-contact surfaces free of accumulations (C) 2. The food-contact surfaces of cooking equipment and pans shall be kept free of encrusted grease deposits and other soil accumulations. 3. Nonfood-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris. 511-6-1.05(7)(a)2,3 - Equipment, Food/Nonfood-Contact Surfaces, and Utensils, food-contact surfaces of cooking equipment & nonfood-contact surfaces free of accumulations (C) 2. The food-contact surfaces of cooking equipment and pans shall be kept free of encrusted grease deposits and other soil accumulations. 3. Nonfood-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris.

Garbage/refuse properly disposed; facilities maintained — Inspector Note: Observed excessive grease accumulation on top and around grease receptacle located adjacent to dumpster. Also observed trash accumulation around outside dumpster. 511-6-1.06(5)(q) - Cleaning Receptacles, in manner to prevent contamination and build-up (C) (q) Cleaning Receptacles. 1. Receptacles and waste handling units for refuse, recyclables, and returnables shall be thoroughly cleaned in a way that does not contaminate food, equipment, utensils, linens, or single-service and single-use articles, and waste water shall be disposed of as specified under subsection (4)(e) of this Rule. 2. Soiled receptacles and waste handling units for refuse, recyclables, and returnables shall be cleaned at a frequency necessary to prevent them from developing a buildup of soil or becoming attractants for insects and rodents.

Physical facilities installed, maintained, and clean — Inspector Note: Observed rust accumulation on walls in kitchen area and foam exposed on wall adjacent to kitchen entrance. Also observed walls above fryers with dust and grease accumulation, as well as excessive dust accumulation on ceiling tiles prep areas. 511-6-1.07(5)(a),(b) - Good Repair, physical facilities maintained; Cleaning, Frequency & Restrictions, cleaned often enough to keep them clean (C) (5) Maintenance and Operation. (a) Good Repair. All physical facilities shall be maintained in good repair. (b) Cleaning, Frequency and Restrictions. 1. The physical facilities shall be cleaned as often as necessary to keep them clean and by methods that prevent contamination of food products. 2. Except for cleaning that is necessary due to a spill or other accident, cleaning shall be done during periods when the least amount of food is exposed, such as after closing. 3. If present, playground equipment and associated areas shall be maintained in a clean and sanitary condition. In addition, a cleaning and sanitizing plan along with cleaning and sanitizing records for playground equipment and associated areas shall be maintained within the food service establishment for review upon request by the Health Authority. Further, such cleaning and sanitizing plan for employees to follow in the event of encountering vomitus or fecal matter shall be included and submitted at the time of permit application as specified in DPH Rule 511-6-1-.02(1)(c). Pf 511-6-1.07(5)(a),(b) - Good Repair, physical facilities maintained; Cleaning, Frequency & Restrictions, cleaned often enough to keep them clean (C) (5) Maintenance and Operation. (a) Good Repair. All physical facilities shall be maintained in good repair. (b) Cleaning, Frequency and Restrictions. 1. The physical facilities shall be cleaned as often as necessary to keep them clean and by methods that prevent contamination of food products. 2. Except for cleaning that is necessary due to a spill or other accident, cleaning shall be done during periods when the least amount of food is exposed, such as after closing.

Adequate ventilation and lighting; designated areas used — Inspector Note: Observed excessive grease accumulation on vent hood filters and on walls above grills. 511-6-1.05(3)(d) - Ventilation Hood System, Adequacy, adequate to prevent grease & condensation build-up (C) (d) Ventilation Hood Systems, Adequacy. Ventilation hood systems and devices shall be sufficient in number and capacity to prevent grease or condensation from collecting on walls and ceilings.

Toxic substances properly identified, stored, used — Inspector Note: Observed spray bottles with purple solution without labels. The manager stated that the bottles contained degreaser. 511-6-1.07(6)(b) - Working Containers, Common Name (Pf) (b) Working Containers, Common Name. Working containers used for storing poisonous or toxic materials such as cleaners and sanitizers taken from bulk supplies shall be clearly and individually identified with the common name of the material. Pf

Contamination prevented during food preparation, storage, display — Inspector Note: Observed buckets of pickles stored on the floor in the walk in cooler. PIC corrected on site by placing the bucket on a rack six inches above the floor. 511-6-1.04(4)(q) - Food Storage (C) (q) Food Storage. 1. Except as specified in paragraphs 2 and 3 of this subsection, food shall be protected from contamination by storing the food: (i) In a clean, dry location; (ii) Where it is not exposed to splash, dust, or other contamination; and (iii) At least 6 inches (15 cm) above the floor. 2. Food in packages and working containers may be stored less than 6 inches (15 cm) above the floor on case lot handling equipment if the equipment can be moved by hand or by conveniently available apparatuses such as hand trucks and forklifts. 3. Pressurized beverage containers, cased food in waterproof containers such as bottles or cans, and milk containers in plastic crates may be stored on a floor that is clean and not exposed to floor moisture.

Food and nonfood-contact surfaces cleanable, properly designed, constructed, and used — Inspector Note: Observed rust build up on the bottom of the preparation table. 511-6-1.05(1)(i) - Nonfood-contact Surfaces (C) (i) Nonfood-contact Surfaces. Nonfood-contact surfaces of equipment that are exposed to splash, spillage, or other food soiling or that require frequent cleaning shall be constructed of a corrosion-resistant, nonabsorbent, and smooth material.

Nonfood-contact surfaces clean — Inspector Note: Observed excessive build up in the housing area of the deep fryers. PIC was advised to clean the area on a regular basis to prevent further build up. PIC will clean the housing area of the deep fryers by 10/15/25.

Plumbing installed; proper backflow devices — Inspector Note: Observed condensation leaking from the bottom of the reach in cooler. PIC will contact maintenance and have the cooler repaired by 10/10/25.

Garbage/refuse properly disposed; facilities maintained — Inspector Note: Observed old grease build up on top of the grease receptacle located next to the dumpster. 511-6-1.06(5)(q) - Cleaning Receptacles, in manner to prevent contamination and build-up (C) (q) Cleaning Receptacles. 1. Receptacles and waste handling units for refuse, recyclables, and returnables shall be thoroughly cleaned in a way that does not contaminate food, equipment, utensils, linens, or single-service and single-use articles, and waste water shall be disposed of as specified under subsection (4)(e) of this Rule. 2. Soiled receptacles and waste handling units for refuse, recyclables, and returnables shall be cleaned at a frequency necessary to prevent them from developing a buildup of soil or becoming attractants for insects and rodents.

Physical facilities installed, maintained, and clean — Inspector Note: Observed rust build up on walls in the walk in cooler and kitchen areas. Also observed dirt and rust in the mop sink area.

Adequate ventilation and lighting; designated areas used — Inspector Note: Observed rust build up on several vents in the kitchen area. This is an ongoing repeat violation. The ceiling vents and walls must be cleaned, treated, and repainted by 11/1/25. Also observed grease build up in the hood vents above the fryers. PIC will have the hood cleaned by 10/15/25. 511-6-1.05(3)(d) - Ventilation Hood System, Adequacy, adequate to prevent grease & condensation build-up (C) (d) Ventilation Hood Systems, Adequacy. Ventilation hood systems and devices shall be sufficient in number and capacity to prevent grease or condensation from collecting on walls and ceilings. 511-6-1.07(2)(j) - Heating, Ventilation, Air Conditioning, System Vents, designed to prevent contamination (C) (j) Heating, Ventilating, Air Conditioning, System Vents. Heating, ventilating, and air conditioning systems shall be designed and installed so that make-up air intake and exhaust vents do not cause contamination of food, food-contact surfaces, equipment, or utensils.

Insects, rodents, and animals not present — Inspector Note: observed self closures on the back door in bad repair. PIC will have the self closure repaired by 10/15/25. This is a repeat violation. 511-6-1.07(2)(m) - Outer Openings Protected (C) (m) Outer Openings, Protected. 1. Except as specified in paragraphs 2 through 5 of this subsection, outer openings of a food service establishment shall be protected against the entry of insects and rodents by: (i) Filling or closing holes and other gaps along floors, walls, and ceilings; (ii) Closed, tight-fitting windows; and (iii) Solid, self-closing, tight-fitting doors. 2. The requirements in paragraph 1 of this subsection does not apply if a food service establishment opens into a larger structure, such as a mall, airport, or office building, or into an attached structure, such as a porch, and the outer openings from the larger or attached structure are protected against the entry of insects and rodents. 3. Exterior doors used as exits need not be self-closing if they are: (i) Solid and tight-fitting; (ii) Designated for use only when an emergency exists, by the fire protection authority that has jurisdiction over the food establishment; and (iii) Limited-use so they are not used for entrance or exit from the building for purposes other than the designated emergency exit use. 4. Except as specified in paragraphs 2 and 5 of this subsection, if the windows or doors of a food service establishment, or of a larger structure within which a food service establishment is located, are kept open for ventilation or other purposes or a temporary food service establishment is not provided with windows and doors as specified under paragraph 1 of this subsection, the openings shall be protected against the entry of insects and rodents by: (i) 16 mesh to 1 inch (16 mesh to 25.4 mm) screens; (ii) Properly designed and installed air curtains to control flying insects; or (iii) Other effective means. 5. The requirement in paragraph 4 of this subsection does not apply if flying insects and other pests are absent due to the location of the establishment, the weather, or other limiting condition.