Marco's Pizza

Wiping cloths: properly used and stored — Inspector Note: Observed wiping cloths stored in a quaternary ammonium sanitizer solution not at a proper minimum concentration. PIC remade solution.

Plumbing installed; proper backflow devices — Inspector Note: Observed evidence of walk-in cooler refrigeration unit leaking; excessive water was observed on enclosed box stored under unit and on open box of prepackaged single serving sauces, and droplets of water on the floor of the cooler. Also observed catch container, full of water, in reach-in cooler under refrigeration unit. PIC stated that cooler has been leaking and that catch pan is disposed of daily. 511-6-1.06(2)(r) - System Maintained in Good Repair (P, C) (r) System Maintained in Good Repair. A plumbing system shall be repaired according to law; P and maintained in good repair.

Garbage/refuse properly disposed; facilities maintained — Inspector Note: Observed trash accumulation around outside dumpster. 511-6-1.06(5)(o),(p) - Using Drain Plugs; Maintaining Refuse Areas (C) (o) Using Drain Plugs. Drains in receptacles and waste handling units for refuse, recyclables, and returnables shall have drain plugs in place. (p) Maintaining Refuse Areas and Enclosures. A storage area and enclosure for refuse, recyclables, or returnables shall be maintained free of unnecessary items and clean.

Physical facilities installed, maintained, and clean — Inspector Note: Observed holes in wall adjacent to handwashing sink at the front of the facility and ceiling tile in disrepair in dining/employee area. PIC was advised to have area sealed. 511-6-1.07(5)(a),(b) - Good Repair, physical facilities maintained; Cleaning, Frequency & Restrictions, cleaned often enough to keep them clean (C) (5) Maintenance and Operation. (a) Good Repair. All physical facilities shall be maintained in good repair. (b) Cleaning, Frequency and Restrictions. 1. The physical facilities shall be cleaned as often as necessary to keep them clean and by methods that prevent contamination of food products. 2. Except for cleaning that is necessary due to a spill or other accident, cleaning shall be done during periods when the least amount of food is exposed, such as after closing.

Food-contact surfaces: cleaned & sanitized — Inspector Note: Observed 3-compartment sink utilizing a quaternary ammonium sanitizer solution below proper minimum concentration. PIC was able to fix the dispensing of the sanitizer and solution was remade to proper concentration. 511-6-1.05(6)(n) - Manual and Mechanical Warewashing Equipment, Chemical Sanitization-Temperature, pH, Concentration, Hardness (P,Pf)

Food-contact surfaces: cleaned & sanitized — Inspector Note: Observed blade of can opener with black and other old food accumulation. 511-6-1.05(7)(b) - Food Contact Surfaces and Utensils - Cleaning Frequency (P, C) (b) Equipment Food-Contact Surfaces and Utensils.

Food and nonfood-contact surfaces cleanable, properly designed, constructed, and used — Inspector Note: Observed floors in walk-in cooler in need of resealing and walk-in cooler door not properly closing. 511-6-1.05(6)(a) - Good Repair & Proper Adjustment (C) (6) Maintenance and Operation. (a) Good Repair and Proper Adjustment. 1. Equipment shall be maintained in a state of repair and condition that meets the requirements specified under subsections (1) and (2)of this Rule. 2. Equipment components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturer's specifications. 3. Cutting or piercing parts of can openers shall be kept sharp to minimize the creation of metal fragments that can contaminate food when the container is opened.

Nonfood-contact surfaces clean — Inspector Note: Observed rust and debris accumulation on shelving in walk-in cooler, and chipping paint and rust accumulation on reach-in cooler shelving. 511-6-1.05(7)(d) - Nonfood-Contact Surfaces (C) (d) Nonfood-Contact Surfaces. Nonfood-contact surfaces of equipment shall be cleaned at a frequency necessary to preclude accumulation of soil residues.

Plumbing installed; proper backflow devices — Inspector Note: Observed leaking around men's restroom faucet. 511-6-1.06(2)(r) - System Maintained in Good Repair (P, C) (r) System Maintained in Good Repair. A plumbing system shall be repaired according to law; P and maintained in good repair.

Physical facilities installed, maintained, and clean — Inspector Note: Observed cardboard boxes being used to absorb grease and hold flour debris from mixers. 511-6-1.07(2)(e) - Floor Covering, Mats & Duckboards (C) (e) Floor Covering, Mats and Duckboards. Mats and duckboards shall be designed to be removable and easily cleanable.

Adequate ventilation and lighting; designated areas used — Inspector Note: Observed employee belongings( cup and keys) stored with single use food boxes/containers. 511-6-1.07(4)(b) - Designated Areas for Employee Activity, located to prevent contamination of food, equipment, utensils, linens, & single service articles (C) (b) Designated Areas for Employee Activity. 1. Areas designated for employees to eat, drink, use tobacco products and electronic devices shall be located so that food, equipment, linens, and single-service and single-use articles are protected from contamination. 2. Lockers or other suitable facilities shall be located in a designated room or area where contamination of food, equipment, utensils, linens and single-service and single-use articles cannot occur.

Food-contact surfaces: cleaned & sanitized — Inspector Note: Observed 3-compartment sink with quaternary ammonium sanitizer solution greater than 400 ppm. Employee began to add more water to dilute the solution. 511-6-1.05(6)(n) - Manual and Mechanical Warewashing Equipment, Chemical Sanitization-Temperature, pH, Concentration, Hardness (P,Pf) (n) Manual and Mechanical Warewashing Equipment, Chemical Sanitization - Temperature, pH, Concentration, and Hardness. A chemical sanitizer used in a sanitizing solution for a manual or mechanical operation at contact times specified under subsection (8)(b)3 of this Rule shall meet the requirements specified in DPH Rule 511-6-1-.07(6)(g), shall be used in accordance with the Environmental Protection Agency (EPA)-registered label use instructions P, and shall be used as follows: 1. A chlorine solution shall have a minimum temperature based on the concentration and pH of the solution as listed in the following chart; P Concentration Range Minimum Temperature MG/L PH 10 or less oF (oC) PH 8 or less oF (oC) 25-49 120 (49) 120 (49) 50-99 100 (38) 75 (24) 100 55 (13) 55 (13) 2. An iodine solution shall have a minimum temperature of 68°F (20°C)P minimum concentration between 12.5 ppm and 25 ppm, P and pH of 5.0 or less or a pH no higher than the level for which the manufacturer specifies for the solution to be effective; P 3. A quaternary ammonium compound solution shall have a minimum temperature of 75ºF (24ºC), P have a concentration as specified in DPH Rule 511-6-1-.07(6)(g) and as indicated by the manufacturer’s use directions included in the labeling, P and be used only in water with 500 ppm hardness or less or in water having a hardness no greater than specified by the EPA-registered label use instructions; P 4. If another solution of a chemical specified under paragraphs 1 through 3 of this subsection is used, the permit holder shall demonstrate to the Health Authority that the solution achieves sanitization and the use of the solution shall be approved; P 5. If a chemical sanitizer other than chlorine, iodine, or a quaternary ammonium compound is used, it shall be applied in accordance with the EPA-registered label use instructions ;P and 6. If a chemical sanitizer is generated by a device located on-site at the food service establishment, it shall be used as specified in 1-5 of this subsection and shall be produced by a device that: (i) complies with law as specified in sections 2(q)(1) and 12 of the Federal Insecticide, Fungicide, and Rodenticide Act (FIFRA), P (ii) complies with 40 CFR 152.500 Requirement for Devices and 40 CFR 156.10 Labeling Requirements, P (iii) displays the EPA device manufacturing facility registration number on the device, Pf and (iv) is operated and maintained in accordance with manufacturer’s instructions. Pf. 7. On-site chemical sanitizer generating equipment with active ingredients, such as copper, must be registered as pesticides. The active ingredient may be part of the equipment or separately added.