RuChDa

Wiping cloths: properly used and stored — Inspector Note: Observed wiping clothes stored in a quaternary ammonium sanitizer solution above 400 ppm. Employee diluted sanitizer solution. 511-6-1.04(4)(m) - Wiping Cloths, Use Limitation (C) (m) Wiping Cloths, Use Limitation. 1. Cloths in-use for wiping food spills from tableware and carry-out containers that occur as food is being served shall be: (i) Maintained dry; and (ii) Used for no other purpose. 2. Cloths in-use for wiping counters and other equipment surfaces shall be: (i) Held between uses in a chemical sanitizer solution at a concentration specified under DPH Rule 511-6-1-.05(6)(n); and (ii) Laundered daily. 3. Cloths in-use for wiping surfaces in contact with raw animal foods shall be kept separate from cloths used for other purposes. 4. Dry wiping cloths and the chemical sanitizing solutions in which wet wiping cloths are held between uses shall be free of food debris and visible soil. 5. Containers of chemical sanitizing solutions in which wet wiping cloths are held between uses shall be stored off the floor and used in a manner that prevents contamination of food, equipment, utensils, linens, single-service, or single-use articles. 6. Single-use disposable sanitizer wipes shall be used in accordance with EPA-approved manufacturer’s label use instructions.

Physical facilities installed, maintained, and clean — Inspector Note: Observed cardboard on floors in front of fryers. 511-6-1.07(1)(a) - Indoor Materials (C) (1) Materials for Construction and Repair. (a) Indoor Materials. Materials for indoor floor, wall, and ceiling surfaces under conditions of normal use shall be: 1. Smooth, durable, and easily cleanable for areas where food service establishment operations are conducted; 2. Closely woven and easily cleanable carpet for carpeted areas; and 3. Nonabsorbent for areas subject to moisture such as food preparation areas, walk-in refrigerators, warewashing areas, toilet rooms, mobile food service unit servicing areas, and areas subject to flushing or spray cleaning methods.

Adequate ventilation and lighting; designated areas used — Inspector Note: Observed employee food items stored improperly. 511-6-1.07(4)(b) - Designated Areas for Employee Activity, located to prevent contamination of food, equipment, utensils, linens, & single service articles (C) (b) Designated Areas for Employee Activity. 1. Areas designated for employees to eat, drink, use tobacco products and electronic devices shall be located so that food, equipment, linens, and single-service and single-use articles are protected from contamination. 2. Lockers or other suitable facilities shall be located in a designated room or area where contamination of food, equipment, utensils, linens and single-service and single-use articles cannot occur.

Adequate ventilation and lighting; designated areas used — Inspector Note: Observed strong odor in men's and women's restroom. 511-6-1.07(3)(g) - Mechanical Ventilation, sufficient capacity to prevent buildup of heat, steam, smoke, fumes & odors (C) (g) Mechanical Ventilation. If necessary to keep rooms free of excessive heat, steam, condensation, vapors, obnoxious odors, smoke, and fumes, mechanical ventilation of sufficient capacity shall be provided.

Insects, rodents, and animals not present — Inspector Note: Observed gaps at the bottom of the back door. 511-6-1.07(2)(m) - Outer Openings Protected (C) (m) Outer Openings, Protected. 1. Except as specified in paragraphs 2 through 5 of this subsection, outer openings of a food service establishment shall be protected against the entry of insects and rodents by: (i) Filling or closing holes and other gaps along floors, walls, and ceilings; (ii) Closed, tight-fitting windows; and (iii) Solid, self-closing, tight-fitting doors. 2. The requirements in paragraph 1 of this subsection does not apply if a food service establishment opens into a larger structure, such as a mall, airport, or office building, or into an attached structure, such as a porch, and the outer openings from the larger or attached structure are protected against the entry of insects and rodents. 3. Exterior doors used as exits need not be self-closing if they are: (i) Solid and tight-fitting; (ii) Designated for use only when an emergency exists, by the fire protection authority that has jurisdiction over the food establishment; and (iii) Limited-use so they are not used for entrance or exit from the building for purposes other than the designated emergency exit use. 4. Except as specified in paragraphs 2 and 5 of this subsection, if the windows or doors of a food service establishment, or of a larger structure within which a food service establishment is located, are kept open for ventilation or other purposes or a temporary food service establishment is not provided with windows and doors as specified under paragraph 1 of this subsection, the openings shall be protected against the entry of insects and rodents by: (i) 16 mesh to 1 inch (16 mesh to 25.4 mm) screens; (ii) Properly designed and installed air curtains to control flying insects; or (iii) Other effective means. 5. The requirement in paragraph 4 of this subsection does not apply if flying insects and other pests are absent due to the location of the establishment, the weather, or other limiting condition.

Insects, rodents, and animals not present — Inspector Note: Observed small insects on sticky traps in restrooms and main kitchen adjacent to water heater. PIC was advised to remove items. 511-6-1.07(5)(l) - Removing Dead or Trapped Birds, Insects, Rodents, and Other Pest (C) (l) Removing Dead or Trapped Birds, Insects, Rodents, and Other Pests. Dead or trapped birds, insects, rodents, and other pests shall be removed from control devices and the premises at a frequency that prevents their accumulation, decomposition, or the attraction of pests.

Food and nonfood-contact surfaces cleanable, properly designed, constructed, and used — Inspector Note: Observed front service reach on cooler door not tightly fitted. 511-6-1.05(6)(a) - Good Repair & Proper Adjustment (C) (6) Maintenance and Operation. (a) Good Repair and Proper Adjustment. 1. Equipment shall be maintained in a state of repair and condition that meets the requirements specified under subsections (1) and (2)of this Rule. 2. Equipment components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturer's specifications. 3. Cutting or piercing parts of can openers shall be kept sharp to minimize the creation of metal fragments that can contaminate food when the container is opened.

Nonfood-contact surfaces clean — Inspector Note: Observed excessive grease accumulation on sides of fryers and on cart adjacent to fryers, and black accumulation on side of vegetable washing sink. 511-6-1.05(7)(a)2,3 - Equipment, Food/Nonfood-Contact Surfaces, and Utensils, food-contact surfaces of cooking equipment & nonfood-contact surfaces free of accumulations (C) 2. The food-contact surfaces of cooking equipment and pans shall be kept free of encrusted grease deposits and other soil accumulations. 3. Nonfood-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris.

Toilet facilities: properly constructed, supplied, cleaned — Inspector Note: Observed white and green accumulation on faucet in men's restroom. 511-6-1.07(5)(h) - Cleaning Plumbing Fixtures- Handsinks, Urinals & Toilets (C) (h) Cleaning of Plumbing Fixtures. Plumbing fixtures such as handwashing sinks, toilets, and urinals shall be cleaned as often as necessary to keep them clean and maintained.

Physical facilities installed, maintained, and clean — Inspector Note: Observed cardboard on floor in front of fryers. 511-6-1.07(1)(a) - Indoor Materials (C) (1) Materials for Construction and Repair. (a) Indoor Materials. Materials for indoor floor, wall, and ceiling surfaces under conditions of normal use shall be: 1. Smooth, durable, and easily cleanable for areas where food service establishment operations are conducted; 2. Closely woven and easily cleanable carpet for carpeted areas; and 3. Nonabsorbent for areas subject to moisture such as food preparation areas, walk-in refrigerators, warewashing areas, toilet rooms, mobile food service unit servicing areas, and areas subject to flushing or spray cleaning methods.

Adequate ventilation and lighting; designated areas used — Inspector Note: Observed dust accumulation on AC vents near the restrooms and on vents in men's and women's restroom. Also, observed excessive grease accumulation under grease hood 511-6-1.07(5)(d) - Cleaning Ventilation System, Nuisance & Discharge Prohibition, cleaned in way not to cause contamination or create a public health hazard (C) (d) Cleaning Ventilation Systems, Nuisance and Discharge Prohibition. Intake and exhaust air ducts shall be cleaned and filters changed so they are not a source of contamination by dust, dirt, and other materials. If vented to the outside, ventilation systems may not create a public health hazard or nuisance or unlawful discharge.