Touchdown Wings

Food and nonfood-contact surfaces cleanable, properly designed, constructed, and used — Inspector Note: Observed white cardboard-like material being used as a cutting surface. Employee discarded of cutting surface. Also observed carboard being used to line shelves. 511-6-1.05(1)(a) - Materials, General Requirements (P, C) (1) Materials. (a) General Requirements. Utensils and food-contact surfaces of equipment shall be made of materials that do not allow the migration of deleterious substances or impart colors, odors, or tastes to food and under normal use conditions, and shall be: P safe P, durable, corrosion-resistant, and nonabsorbent. In addition, materials shall be sufficient in weight and thickness to withstand repeated warewashing and shall be finished to have a smooth, easily cleanable surface. Materials shall be resistant to pitting, chipping, crazing, scratching, scoring, distortion and decomposition.

Plumbing installed; proper backflow devices — Inspector Note: Observed walk-in freezer refrigeration unit with evidence of leaking (icicle formation on piping). 511-6-1.06(2)(r) - System Maintained in Good Repair (P, C) (r) System Maintained in Good Repair. A plumbing system shall be repaired according to law; P and maintained in good repair.

Garbage/refuse properly disposed; facilities maintained — Inspector Note: Observed trash accumulation around outside dumpster. PIC was advised to remove trash build-up. 511-6-1.06(5)(o),(p) - Using Drain Plugs; Maintaining Refuse Areas (C) (o) Using Drain Plugs. Drains in receptacles and waste handling units for refuse, recyclables, and returnables shall have drain plugs in place. (p) Maintaining Refuse Areas and Enclosures. A storage area and enclosure for refuse, recyclables, or returnables shall be maintained free of unnecessary items and clean.

Insects, rodents, and animals not present — Inspector Note: Observed back screen door with large gaps. PIC was advised to seal screen door. 511-6-1.07(2)(m) - Outer Openings Protected (C) (m) Outer Openings, Protected. 1. Except as specified in paragraphs 2 through 5 of this subsection, outer openings of a food service establishment shall be protected against the entry of insects and rodents by: (i) Filling or closing holes and other gaps along floors, walls, and ceilings; (ii) Closed, tight-fitting windows; and (iii) Solid, self-closing, tight-fitting doors. 2. The requirements in paragraph 1 of this subsection does not apply if a food service establishment opens into a larger structure, such as a mall, airport, or office building, or into an attached structure, such as a porch, and the outer openings from the larger or attached structure are protected against the entry of insects and rodents. 3. Exterior doors used as exits need not be self-closing if they are: (i) Solid and tight-fitting; (ii) Designated for use only when an emergency exists, by the fire protection authority that has jurisdiction over the food establishment; and (iii) Limited-use so they are not used for entrance or exit from the building for purposes other than the designated emergency exit use. 4. Except as specified in paragraphs 2 and 5 of this subsection, if the windows or doors of a food service establishment, or of a larger structure within which a food service establishment is located, are kept open for ventilation or other purposes or a temporary food service establishment is not provided with windows and doors as specified under paragraph 1 of this subsection, the openings shall be protected against the entry of insects and rodents by: (i) 16 mesh to 1 inch (16 mesh to 25.4 mm) screens; (ii) Properly designed and installed air curtains to control flying insects; or (iii) Other effective means. 5. The requirement in paragraph 4 of this subsection does not apply if flying insects and other pests are absent due to the location of the establishment, the weather, or other limiting condition.

Toxic substances properly identified, stored, used — Inspector Note: Observed unlabeled chemical bottles. PIC was advised to place common name on all items. 511-6-1.07(6)(b) - Working Containers, Common Name (Pf) (b) Working Containers, Common Name. Working containers used for storing poisonous or toxic materials such as cleaners and sanitizers taken from bulk supplies shall be clearly and individually identified with the common name of the material. Pf

Food separated and protected — Inspector Note: Observed raw shelled eggs stored above boxes of broccoli and celery in the walk in cooler. PIC corrected on site by relocating the eggs.

Toxic substances properly identified, stored, used — Inspector Note: Observed cleaning products including glass cleaner, lysol, and Lysol all purpose cleaner stored above single service articles and next to water cups in the service counter area. PIC advised to not store chemicals above or next to food or food contact surfaces. PIC corrected on site. Also observed the location using an unapproved chemical (Raid) stored in the kitchen area. PIC provided a copy of the pest control report from 11/2025. PIC advised to only use roach and ant spray outside of the facility. PIC removed the unapproved chemicals. 511-6-1.07(6)(c) - Storage, Separation (P) (c) Storage, Separation. Poisonous or toxic materials shall be stored so they cannot contaminate food, equipment, utensils, linens, and single-service and single-use articles by: 1. Separating the poisonous or toxic materials by spacing or partitioning; P and 2. Locating the poisonous or toxic materials in an area that is not above food, equipment, utensils, linens, and single-service or single-use articles. This requirement does not apply to equipment and utensil cleaners and sanitizers that are stored in warewashing areas for availability and convenience if the materials are stored to prevent contamination of food, equipment, utensils, linens, and single-service and single-use articles. P