Crust and Craft

Personal cleanliness — Inspector Note: Observed cooks in the kitchen not wearing proper hair restrains and beard restraints. served staff members in the kitchen preparing food with beards that were longer than .5 inches and not wearing effective beard restraints. PIC advised that staff members will be provided with hair and beard restraints by 08/20/26. 511-6-1.03(5)(i) - Hair Restraints (C) (i) Hair Restraints. 1. Employees preparing or handling food shall use effective and clean, disposable or easily cleanable nets or other hair restraints approved by the Health Authority, worn properly to restrain loose hair including beards and mustaches longer than one half inch. 2. This does not apply to employees such as counter staff who only serve beverages and wrapped or packaged foods, hostesses, and wait staff if they present a minimal risk of contaminating exposed food, clean utensils and linens and unwrapped single-service and single-use articles.

Nonfood-contact surfaces clean — Inspector Note: Observed accumulation of dust on the oscillating fan being used in the back of house. 511-6-1.05(7)(a)2,3 - Equipment, Food/Nonfood-Contact Surfaces, and Utensils, food-contact surfaces of cooking equipment & nonfood-contact surfaces free of accumulations (C) 2. The food-contact surfaces of cooking equipment and pans shall be kept free of encrusted grease deposits and other soil accumulations. 3. Nonfood-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris.

Adequate ventilation and lighting; designated areas used — Inspector Note: Observed employee drinks improperly stored. Drinks were stored with tops and straws. Also observed employee belongings (Backpack) stored in the food preparation area. 511-6-1.07(4)(b) - Designated Areas for Employee Activity, located to prevent contamination of food, equipment, utensils, linens, & single service articles (C) (b) Designated Areas for Employee Activity. 1. Areas designated for employees to eat, drink, use tobacco products and electronic devices shall be located so that food, equipment, linens, and single-service and single-use articles are protected from contamination. 2. Lockers or other suitable facilities shall be located in a designated room or area where contamination of food, equipment, utensils, linens and single-service and single-use articles cannot occur.

Insects, rodents, and animals not present — Inspector Note: Observed several house flies and drain flies throughout the kitchen. Also observed gnats near the produce sink. Pest control records indicated small flies during the most recent visit in the back of the kitchen. During the most recent complaint investigation, the PIC was instructed to remove live plants to reduce potential breeding areas for flies. 511-6-1.07(5)(k) - Controlling Pests (Pf, C) (k) Controlling Pests. The presence of insects, rodents, and other pests shall be controlled to minimize their presence on the premises by: 1. Routinely inspecting incoming shipments of food and supplies; 2. Routinely inspecting the premises for evidence of pests; 3. Using methods, if pests are found, such as trapping devices or other means of pest control as specified under subsections (6)(e), (6)(m), and (6)(n) of this Rule; Pf and 4. Eliminating harborage conditions.

Proper cold holding temperatures — Inspector Note: Observed multiple TCS/RTE food items being cold-held at temperatures exceeding 41F at the time of inspection (See temperature chart). The ambient air temperature also exceeded 41 degrees in the lower portion of the cooler. PIC discarded all products being held above 41F. 11-6-1.04(6)(f) - Time/Temperature Control for Safety; Cold Holding (P) (f) Time/Temperature Control for Safety Food, Hot and Cold Holding. Except during preparation, cooking, or cooling, or when time is used as the public health control, time/temperature control for safety food shall be maintained at 41°F (5°C) or below or 135°F (57°C) or above, except that roasts cooked to a temperature and for a time specified in subsection (5)(a)2 of this Rule and reheated using the same temperature and time conditions as cooking may be held at a temperature of 130°F (54°C) or above. P

Nonfood-contact surfaces clean — Inspector Note: Observed a accumulation of build up underneath the exterior of the drink machine. Observed the ice scoop container with rust accumulation. The ice scoop must be replaced to avoid contamination of food item. Observed the shelves in the reach in cooler with build up. Please clean or replace the shelves. 511-6-1.05(7)(a)2,3 - Equipment, Food/Nonfood-Contact Surfaces, and Utensils, food-contact surfaces of cooking equipment & nonfood-contact surfaces free of accumulations (C) 2. The food-contact surfaces of cooking equipment and pans shall be kept free of encrusted grease deposits and other soil accumulations. 3. Nonfood-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris.

Proper reheating procedures for hot holding — Inspector Note: Observed food items being held in the steam well at temperatures below 135F. The cook stated that the food items were reheated to 135F and then move to the steam well to hot hold. Items were reheated up to 165F or above and moved back to the steam well to hot hold (COS). 511-6-1.04(5)(h) - Reheating for Hot holding (P) (h) Reheating for Hot Holding. 1. Except as specified under paragraphs 2, 3, and 5 of this subsection, time/temperature control for safety food that is cooked, cooled, and reheated for hot holding shall be reheated so that all parts of the food reach a temperature of at least 165°F (74°C) for 15 seconds. P 2. Except as specified under paragraph 3 of this subsection, time/temperature control for safety food reheated in a microwave oven for hot holding shall be reheated so that all parts of the food reach a temperature of at least 165°F (74°C) and the food is rotated or stirred, covered, and then allowed to stand covered for 2 minutes after reheating. P 3. Ready-to-eat time/temperature control for safety food that has been commercially processed and packaged in a food processing plant that is inspected by the food regulatory authority that has jurisdiction over the plant, shall be heated to a temperature of at least 135°F (57°C) for hot holding. P 4. Reheating for hot holding shall be done rapidly and the time the food is between the temperatures of 41°F (5°C) and 165°F (74°C) and 41°F (5°C) and 135°F (57°C) for commercially processed food, may not exceed 2 hours. P 5. Remaining unsliced portions of meat roasts that are cooked as specified under subsection (5)(a)2 of this Rule may be reheated for hot holding using the same oven parameters and minimum time and temperature conditions under which it was cooked.