Papa Johns #5101

Personal cleanliness — Inspector Note: Observed PIC wearing false/polish finger nails without using gloves. PIC corrected on site by donning gloves. Also observed staff members with long hair not properly restrained in the food preparation area. PIC will obtain hair restraints. 511-6-1.03(5)(f) - Fingernails (Pf) (f) Fingernails. Employees shall keep their fingernails clean and trimmed to no longer than the tips of the fingers. Pf Unless wearing gloves in good repair, a food employee may not wear fingernail polish or artificial fingernails when working with exposed food. Pf 511-6-1.03(5)(j) - Hair Restraints (C) (i) Hair Restraints. 1. Employees preparing or handling food shall use effective and clean, disposable or easily cleanable nets or other hair restraints approved by the Health Authority, worn properly to restrain loose hair including beards and mustaches longer than one half inch. 2. This does not apply to employees such as counter staff who only serve beverages and wrapped or packaged foods, hostesses, and wait staff if they present a minimal risk of contaminating exposed food, clean utensils and linens and unwrapped single-service and single-use articles.

Garbage/refuse properly disposed; facilities maintained — Inspector Note: Observed the dumpster missing a lid.PIC will contact the landlord and owner to have the dumpster replaced. 511-6-1.06(5)(n) - Covering Receptacles (C) (n) Covering Receptacles. Receptacles and waste handling units for refuse, recyclables, and returnables shall be kept covered: 1. Inside the food service establishment if the receptacles and units: (i) Contain food residue and are not in continuous use; or (ii) After they are filled; and 2. With tight-fitting lids or doors if kept outside the food service establishment.

Adequate ventilation and lighting; designated areas used — Inspector Note: Observed the air conditioning unit was not working. The ambient air temperature was very warm. PIC will have the AC unit repaired. A plan of action will be sent to [REDACTED EMAIL] by 05/20/2026. The General Manager (Jackie Lewis) will send the plan of action. 511-6-1.07(3)(g) - Mechanical Ventilation, sufficient capacity to prevent buildup of heat, steam, smoke, fumes & odors (C) (g) Mechanical Ventilation. If necessary to keep rooms free of excessive heat, steam, condensation, vapors, obnoxious odors, smoke, and fumes, mechanical ventilation of sufficient capacity shall be provided.

Certified Food Protection Manager — Inspector Note: Observed no CFSM for the location. PIC stated that a recent manager left. Facility has 30 days to get a CFSM. Please email a copy of the document to [REDACTED EMAIL]. 511-6-1.03(3)(a) - Food Safety Manager Certification (Pf) Food service establishments shall have in its employ a Certified Food Safety Manager (CFSM) as specified in paragraph (b) of this subsection to ensure food safety is being managed within the food service establishment during all hours of operation as specified within paragraph (d) of this subsection. Pf

Proper cold holding temperatures — Inspector Note: Observed the preparation cooler used for pizza preparation not maintaining the required cold holding temperature of 41 degrees or below. TCS foods (see above) did not meet temperature requirements. The ambient air temperature was observed at 57 degrees. PIC was advised to discard TCS foods in the make/preparation table. PIC will use time as a public health control. PIC will document start and discard time for TPHC. PIC will email a work order to [REDACTED EMAIL] by 5/20/2026. 511-6-1.04(6)(f) - Time/Temperature Control for Safety; Cold Holding (P) (f) Time/Temperature Control for Safety Food, Hot and Cold Holding. Except during preparation, cooking, or cooling, or when time is used as the public health control, time/temperature control for safety food shall be maintained at 41°F (5°C) or below or 135°F (57°C) or above, except that roasts cooked to a temperature and for a time specified in subsection (5)(a)2 of this Rule and reheated using the same temperature and time conditions as cooking may be held at a temperature of 130°F (54°C) or above. P

Thermometers provided and accurate — Inspector Note: Observed no thermometer in the reach in cooler connected to the pizza make table. All units are required to have a thermometer stored in the warmest area of the unit. 511-6-1.05(2)(x) - TMD, Located in Refrigerators/ Hot Holding (Pf, C) (x) Temperature Measuring Devices. 1. In a mechanically refrigerated or hot food storage unit, the sensor of a temperature measuring device shall be located to measure the air temperature in the warmest part of a mechanically refrigerated unit and in the coolest part of a hot food storage unit. 2. Except as specified in paragraph 3 of this subsection, cold or hot holding equipment used for time/temperature control for safety food shall be designed to include and shall be equipped with at least one integral or permanently affixed temperature measuring device that is located to allow easy viewing of the device's temperature display. 3. The requirement in paragraph 2 of this subsection does not apply to equipment for which the placement of a temperature measuring device is not a practical means for measuring the ambient air surrounding the food because of the design, type, and use of the equipment such as insulated food transport containers and salad bars. 4. Temperature measuring devices shall be designed to be easily readable. 5. Food temperature measuring devices and water temperature measuring devices on warewashing machines shall have a numerical scale, printed record, or digital readout in increments no greater than 1ºC or 2ºF in the intended range of use.

In-use utensils: properly stored — Inspector Note: Observed a handle nested in the bulk container of dustinator. The handle must be stored upwards. 511-6-1.04(4)(k) - In-Use Utensils, Between-Use Storage (C) (k)Storage of In-Use Utensils. During pauses in food preparation or dispensing, food preparation and dispensing utensils shall be stored: 1.Except as specified under paragraph 2 of this subsection, in the food with their handles above the top of the food and the container; 2.In food that is not time/temperature control for safety food with their handles above the top of the food within containers or equipment that can be closed, such as bins of sugar, flour, or cinnamon; 3.On a clean portion of the food preparation table or cooking equipment only if the in-use utensil and the food-contact surface of the food preparation table or cooking equipment are cleaned and sanitized at a frequency specified under DPH Rule 511-6-1-.05(7)(b) and (8)(a); 4.In running water of sufficient velocity to flush particulates to the drain, if used with moist food such as ice cream or mashed potatoes; 5. In a clean, protected location if the utensils, such as ice scoops, are used only with a food that is not time/temperature control for safety food; or 6. In a container of water if the water is maintained at a temperature of at least 135°F (57°C) and the container is cleaned at a frequency specified under DPH Rule 511-6-1-.05(7)(b)3(vi).

Nonfood-contact surfaces clean — Inspector Note: Observed floor fans stored on a shelf with a thick accumulation of dust build up. Also observed a dust build up on the vents/blowers in the walk in cooler. Please clean to avoid contamination of food products. 511-6-1.05(7)(d) - Nonfood-Contact Surfaces (C) (d) Nonfood-Contact Surfaces. Nonfood-contact surfaces of equipment shall be cleaned at a frequency necessary to preclude accumulation of soil residues.

Physical facilities installed, maintained, and clean — Inspector Note: Observed the floors throughout the facility in need of a deep cleaning. (Repeat) 511-6-1.07(5)(a),(b) - Good Repair, physical facilities maintained; Cleaning, Frequency & Restrictions, cleaned often enough to keep them clean (C) (5) Maintenance and Operation. (a) Good Repair. All physical facilities shall be maintained in good repair. (b) Cleaning, Frequency and Restrictions. 1. The physical facilities shall be cleaned as often as necessary to keep them clean and by methods that prevent contamination of food products. 2. Except for cleaning that is necessary due to a spill or other accident, cleaning shall be done during periods when the least amount of food is exposed, such as after closing.

Adequate ventilation and lighting; designated areas used — Inspector Note: Observed (2) lights out underneath the ventilation hood system. The lights must be replaced to allow adequate lighting in the food prep area. 511-6-1.07(3)(f) - Lighting Intensity, adequate in food prep, storage & service areas (C) (f) Lighting Intensity. The light intensity shall be: 1. At least 10 foot candles (108 lux) at a distance of 30 inches (75 cm) above the floor, in walk-in refrigeration units and dry food storage areas and in other areas and rooms during periods of cleaning; 2. At least 20 foot candles (215 lux): (i) At a surface where food is provided for consumer self-service such as buffets and salad bars or where fresh produce or packaged foods are sold or offered for consumption; (ii) Inside equipment such as reach-in and under-counter refrigerators; (iii) At a distance of 30 inches (75 cm) above the floor in areas used for handwashing, warewashing, and equipment and utensil storage, and in toilet rooms; and 3. At least 50 foot candles (540 lux) at a surface where a food service employee is working with food or working with utensils or equipment such as knives, slicers, grinders, or saws where employee safety is a factor.