1 Pot Seafood

Physical facilities installed, maintained, and clean — Inspector Note: Observed build up in vents located in the service area. PIC will clean the vents on 3/18/26 511-6-1.07(5)(a),(b) - Good Repair, physical facilities maintained; Cleaning, Frequency & Restrictions, cleaned often enough to keep them clean (C) (5) Maintenance and Operation. (a) Good Repair. All physical facilities shall be maintained in good repair. (b) Cleaning, Frequency and Restrictions. 1. The physical facilities shall be cleaned as often as necessary to keep them clean and by methods that prevent contamination of food products. 2. Except for cleaning that is necessary due to a spill or other accident, cleaning shall be done during periods when the least amount of food is exposed, such as after closing. 3. If present, playground equipment and associated areas shall be maintained in a clean and sanitary condition. In addition, a cleaning and sanitizing plan along with cleaning and sanitizing records for playground equipment and associated areas shall be maintained within the food service establishment for review upon request by the Health Authority. Further, such cleaning and sanitizing plan for employees to follow in the event of encountering vomitus or fecal matter shall be included and submitted at the time of permit application as specified in DPH Rule 511-6-1-.02(1)(c). Pf

Proper cooling time and temperature — Inspector Note: Observed a container of cooked potatoes that did not reach the required temperature of 41 degrees or below after cooling for hours. The potatoes were observed at 48 degrees f. The cooling process began at 11:00am. The temperature was observed at 6:00 pm. As a result, the potatoes were discarded by the PIC. Cooling must be properly documented. 511-6-1.04(6)(d) - Cooling (P) (d) Cooling. 1. Cooked time/temperature control for safety food shall be cooled: (i) Within 2 hours from 135°F (57°C) to 70°F (21°C); P and (ii) Within a total of 6 hours from 135°F (57°C) to 41°F (5°C) or less. P 2. Time/temperature control for safety food shall be cooled within 4 hours to 41°F (5°C) or less if prepared from ingredients at ambient temperature, such as reconstituted foods and canned tuna. P 3. Except as specified under paragraph 4 of this subsection, a time/temperature control for safety food received in compliance with laws allowing a temperature above 41°F (5°C) during shipment from the supplier shall be cooled within 4 hours to 41°F (5°C). P 4. Raw eggs shall be received and immediately placed in refrigerated equipment that maintains an ambient air temperature of 41°F (5°C) or less. P

In-use utensils: properly stored — Inspector Note: Observed the handle on the spoon laying in the dirty rice mix. Handles should be stored upwards to not cause contamination to the food items. 511-6-1.04(4)(k) - In-Use Utensils, Between-Use Storage (C) (k)Storage of In-Use Utensils. During pauses in food preparation or dispensing, food preparation and dispensing utensils shall be stored: 1.Except as specified under paragraph 2 of this subsection, in the food with their handles above the top of the food and the container; 2.In food that is not time/temperature control for safety food with their handles above the top of the food within containers or equipment that can be closed, such as bins of sugar, flour, or cinnamon; 3.On a clean portion of the food preparation table or cooking equipment only if the in-use utensil and the food-contact surface of the food preparation table or cooking equipment are cleaned and sanitized at a frequency specified under DPH Rule 511-6-1-.05(7)(b) and (8)(a); 4.In running water of sufficient velocity to flush particulates to the drain, if used with moist food such as ice cream or mashed potatoes; 5. In a clean, protected location if the utensils, such as ice scoops, are used only with a food that is not time/temperature control for safety food; or 6. In a container of water if the water is maintained at a temperature of at least 135°F (57°C) and the container is cleaned at a frequency specified under DPH Rule 511-6-1-.05(7)(b)3(vi).

Utensils, equipment and linens: properly stored, dried, handled — Inspector Note: Observed clean dishes (bowls, pots, and pans) stored underneath tables in the kitchen and the dry storage room not inverted to protect from contamination. Advised PIC to make sure all clean items are inverted.

Food and nonfood-contact surfaces cleanable, properly designed, constructed, and used — Inspector Note: Observed the cutting board connected to the prep top cooler in need of replacing due to deep cuts and stains. The cutting boards can be resurfaced or replaced. 511-6-1.05(6)(b) - Cutting Surfaces (C) (b) Cutting Surfaces. Surfaces such as cutting blocks and boards that are subject to scratching and scoring shall be resurfaced if they can no longer be effectively cleaned and sanitized, or discarded if they cannot be resurfaced.

Adequate handwashing facilities supplied & accessible — Inspector Note: Observed a floor fan stored on top of the handwashing sink blocking the sink and making it not accessible for use. PIC removed the fan so the sink will not be blocked (COS). 511-6-1.06(2)(o) - Using a Handwashing Sink- Operation & maintenance (Pf) (o) Using a Handwashing Sink. 1. A handwashing sink shall be maintained so that it is accessible at all times for employee use. Pf 2. A handwashing facility may not be used for purposes other than handwashing. Pf 3. An automatic handwashing facility shall be used in accordance with manufacturer’s instructions. Pf