Westbury Center McDonough For Nursing and Healing

Plumbing installed; proper backflow devices — Inspector Note: Observed a leak below the three compartment sink. Maintenance manager is working on completing the repairs. The leak will be repaired by 7/31/2026. Also observed a condensation leak coming from the condensing fan unit in the the walk in cooler. 511-6-1.06(2)(r) - System Maintained in Good Repair (P, C) (r) System Maintained in Good Repair. A plumbing system shall be repaired according to law; P and maintained in good repair.

Physical facilities installed, maintained, and clean — Inspector Note: Observed mold build up behind the base boards in the storage area. Also observed build up on vents in the storage area. PIC will have the vents and baseboards cleaned and disinfected by 7/30/2026 511-6-1.07(5)(a),(b) - Good Repair, physical facilities maintained; Cleaning, Frequency & Restrictions, cleaned often enough to keep them clean (C) (5) Maintenance and Operation. (a) Good Repair. All physical facilities shall be maintained in good repair. (b) Cleaning, Frequency and Restrictions. 1. The physical facilities shall be cleaned as often as necessary to keep them clean and by methods that prevent contamination of food products. 2. Except for cleaning that is necessary due to a spill or other accident, cleaning shall be done during periods when the least amount of food is exposed, such as after closing. 3. If present, playground equipment and associated areas shall be maintained in a clean and sanitary condition. In addition, a cleaning and sanitizing plan along with cleaning and sanitizing records for playground equipment and associated areas shall be maintained within the food service establishment for review upon request by the Health Authority. Further, such cleaning and sanitizing plan for employees to follow in the event of encountering vomitus or fecal matter shall be included and submitted at the time of permit application as specified in DPH Rule 511-6-1-.02(1)(c). Pf

Physical facilities installed, maintained, and clean — Inspector Note: Observed mold build up on the wall/baseboards in the storage room. CA- PIC will have the wall/baseboard area cleaned and sanitized by 8/5/26. Also observed ceiling tile in bad repair (hole) in the dishwashing room and the hallway by the back door. Also, observed the floor in the dish area in need of sealing or adding floor tile to make the area smooth, easily cleanable, and nonabsorbent. Observed the top of the ceiling in the walk in cooler in need of cleaning and resealing due to rust accumulation. 511-6-1.07(5)(a),(b) - Good Repair, physical facilities maintained; Cleaning, Frequency & Restrictions, cleaned often enough to keep them clean (C) (5) Maintenance and Operation. (a) Good Repair. All physical facilities shall be maintained in good repair. (b) Cleaning, Frequency and Restrictions. 1. The physical facilities shall be cleaned as often as necessary to keep them clean and by methods that prevent contamination of food products. 2. Except for cleaning that is necessary due to a spill or other accident, cleaning shall be done during periods when the least amount of food is exposed, such as after closing.

Adequate ventilation and lighting; designated areas used — Inspector Note: Observed rust build up on several vents in the kitchen area. Also observed the walk in cooler light intensity has to be increased to facilitate observing food in the walk in cooler. 511-6-1.07(3)(f) - Lighting Intensity, adequate in food prep, storage & service areas (C) (f) Lighting Intensity. The light intensity shall be: 1. At least 10 foot candles (108 lux) at a distance of 30 inches (75 cm) above the floor, in walk-in refrigeration units and dry food storage areas and in other areas and rooms during periods of cleaning; 2. At least 20 foot candles (215 lux): (i) At a surface where food is provided for consumer self-service such as buffets and salad bars or where fresh produce or packaged foods are sold or offered for consumption; (ii) Inside equipment such as reach-in and under-counter refrigerators; (iii) At a distance of 30 inches (75 cm) above the floor in areas used for handwashing, warewashing, and equipment and utensil storage, and in toilet rooms; and 3. At least 50 foot candles (540 lux) at a surface where a food service employee is working with food or working with utensils or equipment such as knives, slicers, grinders, or saws where employee safety is a factor.

Insects, rodents, and animals not present — Inspector Note: Observed rodent droppings on the shelf in the chemical storage area located in the mop sink room. PIC will contact the pest control company to have the area treated and droppings removed by 7/13/26. 511-6-1.07(5)(l) - Removing Dead or Trapped Birds, Insects, Rodents, and Other Pest (C) (l) Removing Dead or Trapped Birds, Insects, Rodents, and Other Pests. Dead or trapped birds, insects, rodents, and other pests shall be removed from control devices and the premises at a frequency that prevents their accumulation, decomposition, or the attraction of pests.

Proper eating, tasting, drinking, or tobacco use — Inspector Note: Observed an employees open water bottle stored near clean dishes and a thermos was observed on the food preparation table. PIC corrected on site. 511-6-1.03(5)(k)1&2 - Eating, Drinking, or Using Tobacco (C) (k) Hygienic Practices. 1. Employees shall not use any form of tobacco products, or electronic devices that simulate tobacco smoking, while engaged in food preparation or service, nor while in areas used for equipment or utensil washing and storage, food preparation or food storage. Employees shall only use tobacco products or electronic devices that simulate tobacco smoking in approved designated areas. 2. Employees shall consume food only in approved designated areas separate from food preparation and serving areas, equipment or utensil areas and food storage areas. However, drinking from a single service beverage cup with a secure lid and straw that is handled to prevent contamination of the employee’s hands, the container, exposed food, clean equipment, utensils and linens, unwrapped single-service and single-use articles will be allowed.

Utensils, equipment and linens: properly stored, dried, handled — Inspector Note: Observed plates stored unprotected in the kitchen area. PIC corrected on site by inverting plates. PIC was also provided with an option to cover plates to prevent contamination. 511-6-1.05(10)(e)1,2,4 - Equipment, Utensil, Linens, stored 6" off floor in clean, dry location (C) (e) Equipment, Utensils, Linens, and Single-Service and Single-Use Articles. 1. Except as specified in paragraph 4 of this subsection, cleaned equipment and utensils, laundered linens, and single-service and single-use articles shall be stored: (i) In a clean, dry location; (ii) Where they are not exposed to splash, dust, or other contamination; and (iii) At least 6 inches (15 centimeters) above the floor. 2. Clean equipment and utensils shall be stored as specified under paragraph 1 of this subsection and shall be stored: (i) In a self-draining position that allows air drying; and (ii) Covered or inverted. 4. Items that are kept in closed packages may be stored less than 6 inches (15 centimeters) above the floor on dollies, pallets, racks, and skids that are designed as specified under subsection (2)(hh) of this Rule.

Food and nonfood-contact surfaces cleanable, properly designed, constructed, and used — Inspector Note: Observed a wire basket skimmer containing broken wires in the utensil storage area. PIC corrected on site by discarding the utensil to prevent potential physical injury. 511-6-1.05(2)(c) - Multiuse Food-Contact Surfaces (Pf) (c) Multiuse Food-Contact Surfaces. 1. Multiuse food-contact surfaces shall be: (i) Smooth; Pf (ii) Free of breaks, open seams, cracks, chips, inclusions, pits, and similar imperfections; Pf (iii) Free of sharp internal angles, corners, and crevices; Pf (iv) Finished to have smooth welds and joints; Pf and (v) Except as specified in paragraph 2 of this subsection, accessible for cleaning and inspection by one of the following methods: (I) Without being disassembled, Pf (II) By disassembling without the use of tools, Pf or (III) By easy disassembling with the use of handheld tools commonly available to maintenance and cleaning personnel such as screwdrivers, pliers, open-end wrenches, and Allen wrenches. Pf 2. The requirement in paragraph 1(v) of this subsection does not apply to cooking oil storage tanks, Distribution lines for cooking oils, or beverage syrup lines or tubes.