Culturistic Kitchen

Posted: Permit/Inspection/Choking Poster/Handwashing — Inspector Note: Observed current food service permit fee unpaid. Manager is also in the process of applying for a mobile food unit and base of operation. Manager was advised that the applications could not be completed until the food service permit fee and late fee are paid no later May 29, 2026. Please visit or contact the health department at [REDACTED PHONE] ext. to pay for the permit ($350) and late fee ($50). Manager was given an Issuance of Legal Notice for the delinquent fees.

Utensils, equipment and linens: properly stored, dried, handled — Inspector Note: Observed lip/food contact surfaces of silverware stored in the ware washing area uncovered. Manager corrected on site.

Food and nonfood-contact surfaces cleanable, properly designed, constructed, and used — Inspector Note: Observed a fryer basket in disrepair.

Physical facilities installed, maintained, and clean — Inspector Note: Observed food debris on the floor under cooking and prep top cooler equipment.

Insects, rodents, and animals not present — Inspector Note: Observed dead insects in the light shield in the ware washing area. Team member removed the light shields and cleaned the bugs.

Utensils, equipment and linens: properly stored, dried, handled — Inspector Note: Observed plates and bowls not stored turned or inverted. Employees inverted plates. 511-6-1.05(10)(e)1,2,4 - Equipment, Utensil, Linens, stored 6" off floor in clean, dry location (C) (e) Equipment, Utensils, Linens, and Single-Service and Single-Use Articles. 1. Except as specified in paragraph 4 of this subsection, cleaned equipment and utensils, laundered linens, and single-service and single-use articles shall be stored: (i) In a clean, dry location; (ii) Where they are not exposed to splash, dust, or other contamination; and (iii) At least 6 inches (15 centimeters) above the floor. 2. Clean equipment and utensils shall be stored as specified under paragraph 1 of this subsection and shall be stored: (i) In a self-draining position that allows air drying; and (ii) Covered or inverted. 4. Items that are kept in closed packages may be stored less than 6 inches (15 centimeters) above the floor on dollies, pallets, racks, and skids that are designed as specified under subsection (2)(hh) of this Rule.

Adequate handwashing facilities supplied & accessible — Inspector Note: Observed no soap at handwashing sink adjacent to oven. Employee placed bottle of handwashing soap. 511-6-1.07(3)(a) - Handwashing Cleanser, Availability (Pf) (3) Numbers and Capacities. (a) Handwashing Cleanser, Availability. Each handwashing sink or group of two adjacent handwashing sinks shall be provided with a supply of hand cleaning liquid, powder, or bar soap. Pf

Food-contact surfaces: cleaned & sanitized — Inspector Note: Observed chlorine sanitizer in dish machine at 0 ppm. Manager stated that machines use would be discontinued and items would be properly sanitized in 3-compartment sink. 511-6-1.05(6)(n) - Manual and Mechanical Warewashing Equipment, Chemical Sanitization-Temperature, pH, Concentration, Hardness (P,Pf) (n) Manual and Mechanical Warewashing Equipment, Chemical Sanitization - Temperature, pH, Concentration, and Hardness. A chemical sanitizer used in a sanitizing solution for a manual or mechanical operation at contact times specified under subsection (8)(b)3 of this Rule shall meet the requirements specified in DPH Rule 511-6-1-.07(6)(g), shall be used in accordance with the Environmental Protection Agency (EPA)-registered label use instructions P, and shall be used as follows: 1. A chlorine solution shall have a minimum temperature based on the concentration and pH of the solution as listed in the following chart; P Concentration Range Minimum Temperature MG/L PH 10 or less oF (oC) PH 8 or less oF (oC) 25-49 120 (49) 120 (49) 50-99 100 (38) 75 (24) 100 55 (13) 55 (13) 2. An iodine solution shall have a minimum temperature of 68°F (20°C)P minimum concentration between 12.5 ppm and 25 ppm, P and pH of 5.0 or less or a pH no higher than the level for which the manufacturer specifies for the solution to be effective; P 3. A quaternary ammonium compound solution shall have a minimum temperature of 75ºF (24ºC), P have a concentration as specified in DPH Rule 511-6-1-.07(6)(g) and as indicated by the manufacturer’s use directions included in the labeling, P and be used only in water with 500 ppm hardness or less or in water having a hardness no greater than specified by the EPA-registered label use instructions; P 4. If another solution of a chemical specified under paragraphs 1 through 3 of this subsection is used, the permit holder shall demonstrate to the Health Authority that the solution achieves sanitization and the use of the solution shall be approved; P 5. If a chemical sanitizer other than chlorine, iodine, or a quaternary ammonium compound is used, it shall be applied in accordance with the EPA-registered label use instructions ;P and 6. If a chemical sanitizer is generated by a device located on-site at the food service establishment, it shall be used as specified in 1-5 of this subsection and shall be produced by a device that: (i) complies with law as specified in sections 2(q)(1) and 12 of the Federal Insecticide, Fungicide, and Rodenticide Act (FIFRA), P (ii) complies with 40 CFR 152.500 Requirement for Devices and 40 CFR 156.10 Labeling Requirements, P (iii) displays the EPA device manufacturing facility registration number on the device, Pf and (iv) is operated and maintained in accordance with manufacturer’s instructions. Pf. 7. On-site chemical sanitizer generating equipment with active ingredients, such as copper, must be registered as pesticides. The active ingredient may be part of the equipment or separately added.