Oasis Nutrition

Thermometers provided and accurate — Inspector Note: Observed a thermometer not provided in the reach in cooler located in the service area. 511-6-1.05(2)(x) - TMD, Located in Refrigerators/ Hot Holding (Pf, C) (x) Temperature Measuring Devices. 1. In a mechanically refrigerated or hot food storage unit, the sensor of a temperature measuring device shall be located to measure the air temperature in the warmest part of a mechanically refrigerated unit and in the coolest part of a hot food storage unit. 2. Except as specified in paragraph 3 of this subsection, cold or hot holding equipment used for time/temperature control for safety food shall be designed to include and shall be equipped with at least one integral or permanently affixed temperature measuring device that is located to allow easy viewing of the device's temperature display. 3. The requirement in paragraph 2 of this subsection does not apply to equipment for which the placement of a temperature measuring device is not a practical means for measuring the ambient air surrounding the food because of the design, type, and use of the equipment such as insulated food transport containers and salad bars. 4. Temperature measuring devices shall be designed to be easily readable. 5. Food temperature measuring devices and water temperature measuring devices on warewashing machines shall have a numerical scale, printed record, or digital readout in increments no greater than 1ºC or 2ºF in the intended range of use. Pf

Warewashing facilities: installed, maintained, used; test strips — Inspector Note: Observed expired chlorine test strips that expired 4/26 and one container expired 2/2023. PIC will obtain test strips by 9/3/26 511-6-1.05(3)(h),(i),(j) - Temperature Measuring Device, Manual Warewashing; Sanitizing Solutions, Testing Device (Pf) (h) Temperature Measuring Devices, Manual and Mechanical Warewashing. 1. In manual warewashing operations, a temperature measuring device shall be provided and readily accessible for frequently measuring the washing and sanitizing temperatures. Pf 2. In hot water mechanical warewashing operations, an irreversible registering temperature indicator shall be provided and readily accessible for measuring the utensil surface temperature. Pf (i) Sanitizing Solutions, Testing Devices. A test kit or other device that accurately measures the concentration in mg/L of sanitizing solutions shall be provided. Pf j) Cleaning Agents and Sanitizers. 1. Cleaning agents that are used to clean equipment and utensils as specified under section (7) of this Rule, shall be provided and available for use during all hours of operation. Pf 2. Except for those that are generated on-site at the time of use, chemical sanitizers that are used to sanitize equipment and utensils, as specified under Section (8) of this Rule, shall be provided and available for use during all hours of operation. Pf

Toilet facilities: properly constructed, supplied, cleaned — Inspector Note: Observed the restroom door not locking properly when closed. PIC will have the lock repaired by 9/4/26.

Adequate ventilation and lighting; designated areas used — Inspector Note: Observed employee medication (Zepbound) not properly labeled for employee use in the reach in cooler.

Proper cold holding temperatures — Inspector Note: Observed half & half, 2 percent lactose free milk, almond milk, toasted coconut vanilla creamer, and oatmilk stored above 41 degrees f in the reach in cooler located in the serving area. TCS foods did not meet the cold holding requirements of 41 degrees or below. The reach in cooler is an unapproved residential cooler that was installed after opening. PIC was instructed to provide a current copy of the menu and install a commercial cooler by 9/4/26. A current menu must be submitted to Don Lucas for review by 9/4/26. 511-6-1.04(6)(f) - Time/Temperature Control for Safety; Cold Holding (P) (f) Time/Temperature Control for Safety Food, Hot and Cold Holding. Except during preparation, cooking, or cooling, or when time is used as the public health control, time/temperature control for safety food shall be maintained at 41°F (5°C) or below or 135°F (57°C) or above, except that roasts cooked to a temperature and for a time specified in subsection (5)(a)2 of this Rule and reheated using the same temperature and time conditions as cooking may be held at a temperature of 130°F (54°C) or above. P